Connecting An Optional Preview Monitor - Dazzle DCS 200 User Manual

VHS
S-Video Out
RCA Video Out
Audio Out
TV

Connecting an Optional Preview Monitor

Although you can preview your video in MovieStar 5, you may prefer to view it at full size on
a TV monitor. To connect an optional preview monitor, follow these steps:
1. Obtain an additional RCA (composite) video cable or S-Video cable (depending on your
configuration) and an additional RCA audio cable (these extra cables may have been
included with your camcorder and/or VCR).
2. Connect one end of the RCA video cable (yellow) or S-video cable (black) and connect
it to the corresponding Video Out connector on the back of the DCS 200.
3. Connect the other end of the video cable to the corresponding Video In connector on
your TV monitor.
Note: Some older model TVs may not have Video In connectors. For specific details,
check the documentation included with your TV.
4. Connect the RCA audio cable (red and white) from the Audio Out connector on the
back of the DCS 200 to the Audio In connector on the TV monitor.
Note: Your additional audio cable may have separate connectors for left and right, or
the connectors might be joined as shown in the illustration above. Remember that you
need to use a Y-adapter if your TV monitor only supports mono input.
IMPORTANT: Make sure that the TV monitor is set up properly to receive a video
signal. It might need to be set to "Line In," "L1," "L2," "Aux" or a similar channel.
Check the monitor's documentation for specific details.
Dazzle DVD Creation Station 200 User's Guide • Capturing Video • Page 16
DCS 200
S-Video Out
S-Video In
Or
RCA Video Out
RCA Video In
Audio Out
Audio In
S-Video In
Or
RCA Video In
TV
Audio In
Optional
Preview Monitor