TROUBLE SHOOTING GUIDE
Your Rebel Treadmill 1000 was tested extensively to ensure proper and safe functioning. In
the event that you experience a problem with the machine, refer to these possible solutions.
If the display on the control panel will not illuminate:
•
The machine's power sources could be compromised.
o Check the master power switch at the front of the machine to ensure it is in the
ON position.
o Inspect the supply cord to ensure that it is fully connected to the outlet and the
machine.
o Inspect the wire from the control panel to ensure it is fully connected to the back
of the control panel.
•
The machine's electrical overload protection could have been activated.
o Turn the machine OFF. Wait five seconds. Turn the machine ON and press
START.
If the display shows "E1":
•
The machine's electrical overload protection could have been activated.
o Turn the machine OFF. Wait five seconds. Turn the machine ON and press
START.
•
There may be too much friction between the treadmill belt and deck. See the
instructions on lubricating the treadmill belt and adjusting the belt.
•
The machine may have a problem that requires servicing by a professional.
Contact Rebel Desk to obtain assistance with servicing.
If the digits on the control panel display are scrambled:
•
The control panel may be damaged and require service by a professional.
Contact Rebel Desk to obtain assistance with servicing.
13