Dh5122 Printhead; Figure 2.7 Dh5122 Printhead - Kodak DP5120 Installation Manual

DH5122 Printhead

Use the following procedure to unpack the 2", 120-dpi printhead:
1. Take the printhead box to the location where the printer is to be
installed (and the second, spare printhead box, if one was included in
the shipment).
2. Open the outer (printhead shipping) box.
3. Remove the following contents of the box (see Figure 2.7):
• Inner printhead box
• Description Kit - Packaging (0189959)
• Swabs (0103007).
Note: The printhead Replacement Instructions (0114252-602) and Packing
Instructions (0114253-602) are in the printer or system installation kit.
4. Note the serial number on the inner box label. This number should
match the printhead serial number on the outer box label. Record this
number for the installation report.
5. Open the inner box.
6. Remove the top cushion section and remove the printhead capsule.
7. Open the printhead capsule and remove the printhead assembly.
Note: Four Phillips screws secure the capsule.
8. Store the printhead assembly in a safe location near the printer until
you are ready for printhead installation.
9. Retain the printhead packaging (outer box, inner box, and capsule).
Note: This packaging must be used if the printhead is returned.
10. Continue with the printer or printing system installation procedure.
Figure 2.7 DH5122 printhead
Chapter 2. Unpacking
Printheads
Installation Guide 2-15