Keyboard And Mouse; Monitor Interface; Figure 4.7 Controller Data, Keyboard And Mouse Cables; Figure 4.8 Video Connection, Controller Pc - Kodak DP5120 Installation Manual

PS/2 mouse
Keyboard (with PS/2 adapter)
Monitor SVGA interface cable

Keyboard and Mouse

The keyboard and mouse have integral cables. Connect the keyboard
adapter (serial to PS/2) packaged with it to the keyboard cable, and then
plug the keyboard into the PS mouse connector on the PC back panel.
Plug the mouse cable into the PS mouse connector on the PC back panel
(see Figure 4.7).
Note: On older Jetscape controllers, GlidePoint was plugged into COM1.
Figure 4.7 Controller data, keyboard and mouse cables

Monitor Interface

Plug the SVGA cable permanently affixed to the monitor into the VIDEO
connector on the PC back panel (see Figure 4.8).
Secure the connector by tightening the set screws until snug; do not over
tighten.
Figure 4.8 Video connection, controller PC
Chapter 4. System Installation
System Connections
Installation Guide 4-7