Advertisement
Accessories
M4 Taping Screw 2EA
Cable Rubber
User Manual
Quick Install Guide
Template
INSTALLATION
Installing Camera
1. Fix the camera to a ceiling or a wall using two screws.
2. After fixing it, adjust its pan base and
Hole
tilt base properly.
3. After adjusting them, secure the shield
case and dome-cover.
Screw
Shield Case
Dome Cover
MINI DOME CAMERA
8
USER'S MANUAL
CAMERA OPERATION
The SID-50 includes the following built in functions
Auto Functions
Setting Value
Descriptions
The speed is controlled according to the
Electronic Shutter
ESC
Speed
brightness of the screen.
It can be used within the color temperature
WHITE BALANCE
range 1,800K~10,500K(Ex fluorescent light,
ATW
outdoor, sodium vapor lamp or inside tunnels)
MIDDLE
The gain increases within the range of
BACKLIGHT
6dB~34dB
The gain increases or decreases within the
GAIN CONTROL
MIDDLE
range of 6dB~34dB
SSNR
There is sufficient reduction in noise levels
LOW
(Noise Reduction)
without causing much ghost imaging
It helps maintain a bright, clear screen image by
automatically detecting changes in the level in
SENS UP
ON
low light levels without causing much ghost
imaging.
The outline of the video image becomes cleaner
and more distinctive as the level of
SHARPNESS
ON
SHARPNESS increases.
MINI DOME CAMERA
12
USER'S MANUAL
Notes
• When installing the camera on a ceiling or a wall, not to disturb adjustment of Tilt Base angle fix
the BNC-Power Cable on the Pan Base clip.
<Installing the camera on a ceiling>
<Installing the camera on a wall>
BNC-Power Cable
Pan Base clip
Connection to Power
•Connect the adapter to the power input connector as shown in the figure below. Use a
DC12V 500mA. (The Adapter is not provided with the Dome Camera.)
DOME Camera
Adapter (not provided)
Power Input Connector
MINI DOME CAMERA
9
USER'S MANUAL
TROBLESHOOTING
If you have trouble operating your camera, refer to the following. If the guidelines do not
enable you to solve the problem, contact an authorized technician.
The image on the screen is dim.
• Check if the lens are stained. If dirty, clean the lens with soft, clean cloth.
• The image is dimmer at night than daytime. If the focus is not right, adjust it at daytime.
The contrast on the screen is too weak.
• Adjust the contrast feature of the monitor.
• If the camera is exposed under too strong light, change the camera position.
• Adjust the lens BACK FOCUS again.
The camera is not work properly, and the surface of the camera case is hot.
• Check that you have connected the camera to a proper power (DC12V ).
DIMENSION
99.2
63.5
99.2
99.2
2-Ø 4.2
MINI DOME CAMERA
13
USER'S MANUAL
For DC Power Type
Resistance of copper wire [at 20C˚ (68˚F)]
Copper wire size (AWG)
#24(0.22mm
2
)
#22(0.33mm
2
)
#20(0.52mm
Resistance ( Ω / m)
0.078
0.050
Voltage Drop (V/m)
0.028
0.018
• As the voltage drop according to the length of the cable in the above table, a camera may
malfunction if there is an excessively long cable run.
* Voltage for camera operation: 12V DC ±10%
* Voltage drops in the above table are variable according to types of cable manufacturer.
Connection to Monitor
Connect the VIDEO-OUT jack to the VIDEO-IN jack of monitor.
•As a connecting method varies according to instruments, refer to the manual supplied with
the instrument.
•Connect the cable after power is turned off.
•Set the 75Ω / Hi-Z selection switch. If it is a intermediate device, switch it to Hi-z and if
it is final device, switch it to 75Ω. (Please refer to the Monitor Manual.)
BNC
Intermediate
DOME Camera
MINI DOME CAMERA
10
USER'S MANUAL
SPECIFICATION
ITEM
SID-50N
DC 12V±10%/Max. 1.8W
Power Source
811(H) x 508(V)
Total Pixels
CCD
Effective Pixels
768(H) x 494(V)
SIZE
1/3 inch Super HAD CCD
2:1 Interlace
Scanning System
Sync.
Internal Only
Synchronization
Frequency
Horizontal:15.734 KHz/Vertical :59.94
LENS(Built-in)
Built-in Fixed Lens 120 f=3.0mm, F2.0
540 TV Lines(Min.)
Resolution
E
CVBS : 1.0Vp-p/75
Video Output
L
S/N(Y signal)
50 dB (AGC Off,Weight ON)
E
Min.Illumination
0.05Lux/F1.2(Sens-up), 0.3Lux/F1.2
C
T
Electronic shutter speed
R
WHITE BALANCE
I
C
BACKLIGHT
Auto Functions
A
Gain Control
L
SENS-UP
SSNR(Noise Control)
SHARPNESS
67
Monitoring
Pan
Manual 360
Manual 20 ~ 90
Angle
Tilt
-10˚C to +50˚C / 30% to 80% RH
Operating temperature/Humidity
Dimention
99.2mm(W) x 99.2mm(H) x 67mm(D)
Weight
MINI DOME CAMERA
14
USER'S MANUAL
Panning & Tilting Control
You can adjust the Panning and Tilting angle freely. (Panning angle: 360°,
2
)
#18(0.83mm
2
)
Tilting angle: 20˚~90˚)
0.030
0.018
0.011
0.006
Tilt Base Holding
Screws
Pan Base
You can rotate the lens
from 360˚
1) Adjustment Panning angle: After attaching the dome camera to a ceiling or a wall, adjust the
panning angle for better monitoring area by rotating the Pan Base. The panning angle can be
adjusted 360˚ freely.
2) Adjustment Tilting angle: After attaching the dome camera to a ceiling or a wall, adjust
the tilting angle for better monitoring area by rotating the Tilt Base. The tilting angle can
be adjusted to 20˚ from 90˚ freely. (based the ceiling surface)
Notes
• After loosening Pan or Tilt Base holding screws, adjust its angle. And then tighten screws again.
• In case of adjusting the tilting, do not take the lens for preventing hysical shocks. Please take the Tilt Base.
• This dome camera is to be installed on the ceiling by factory default. In case of using camera on the wall,
Monitor
readjust the Tilt angle as page 8 (Notes).
MINI DOME CAMERA
DECLARATION OF CONFORMITY
Application of Council Directive(s)
SID-50P
Manufacturer's Name
Manufacturer's Address
795(H) x 596(V)
752(H) x 582(V)
European Representative Name
European Representative Address
Equipment Type/Environment
Model Name
Beginning Serial NO.
Hz Horizontal: 15.625 KHz/Vertical : 50Hz
Year of Manufacture
Conformance to
AUTO
We, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s).
AUTO
Manufacturer
SAMSUNG TECHWIN CO., LTD
Signature
AUTO
Full Name
YOUNG TAEK SON
AUTO
Position
QUALITY CONTROL MANAGER
AUTO
Place
CHANGWON, KOREA
Date
2006. 03. 01
AUTO
AUTO
This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the
end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please
separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources.
200g
Household users should contact either the retailer where they purchased this product, or their local government office, for details
of where and how they can take this item for environmentally safe recycling.
Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not
be mixed with other commercial wastes for disposal.
Tilt Base
You can adjust up and down
the camera (20˚~90˚).
Pan Base Holding Screw
11
USER'S MANUAL
89 / 336 / EEC
SAMSUNG TECHWIN CO., LTD
SAMSUNG TECHWIN CO., LTD
42, SUNGJU-DONG CHANGWON-CITY,
KYUNGNAM, KOREA, 641-120
MINI DOME CAMERA
SID-50
S6300001
2006. 03. 01
EN 50081-1 : 1992
EMC-Directive 89/336 EEC and 92/31/EEC
EN 50130-4 : 1996
Legal Representative in Europe
Signature
Full Name
Position
Place
Date
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems)
Advertisement
