Edirol M-16DX Workshop Manual page 9

In Use
To add the external effect to an M-16DX channel's signal:
On the M-16DX, set Channel 15/16's LEVEL knob straight up as a
1
starting point.
Press the AUX 1 button so it lights—this assigns
2
the channel strips' AUX 1 knob to the sending of
signals to the Aux 1 bus and on to the external
effect. The AUX1 screen appears.
As you listen to signal coming into the channel, adjust the channel's
3
AUX 1 knob until you hear the desired amount of the external effect
on the signal.
You can adjust a channel's AUX 1 send level at any time by simply
turning its AUX 1 knob when the AUX 1 button is lit.
When you're done adding the external effect to your channels' signals
as desired, you can adjust the overall level of the external effect in
your mix using Channel 15/16's LEVEL knob.
If Your External Effect Has Digital Connectors
Since the M-16DX's DIGITAL OUT jacks carry the entire main mix, you can use
an digital external effect processor for the adding of mastering effects to the
mix when you don't want to use the M-16DX's internal Finalize effect.
Connect the digital input connector on your external effect to the
corresponding DIGITAL OUT jack on the front of the M-16DX's I/O module.
You can connect the M-16DX digitally to devices that use phono or optical
S/P DIF digital connections.
Connect the output of the external processor to the device you'll be using as
a recorder, or to power amps in a live performance setting.
The End
We hope you've found this workshop helpful. You'll find other
M-16DX Workshop booklets
www.RolandUS.com/EDIROL.
available for downloading at
9