Using Insert Effects - Edirol M-16DX Workshop Manual

Echo
This effect creates a long repeating delay/echo.
Parameter:
TIME
range: 0.0-6.0 seconds
DAMP
range: 315-8k, BYP
Reverbs: Room, Small Hall, Large Hall
•
Room— This reverb creates a room-like acoustic space around the
signal.
•
Small Hall— This reverb places the signal in a simulated concert-hall
space.
•
Large Hall— This reverb makes the signal sound as if it's in a large
concert hall.
The three reverbs share the same parameters.
Parameter:
P DLY
range: 0.0-160 milliseconds
TIME
range: 0.0-6.0 seconds
DAMP
range: 315-8k, BYP
This parameter
sets the length of time the delay
continues to repeat.
sets the frequency above which the
high end of the delays are reduced in
volume to create a trailing-off effect.
With the BYP (Bypass) setting, no high
end is rolled-off.
This parameter
sets the amount of time that passes
before the reverb begins, to imply
the distance between the signal and
the walls of the simulated space.
adjusts the length of the reverb and
thus the size of the simulated space.
sets the frequency above which the
high end of the reverb is reduced as
it trails away. With the BYP (Bypass)
setting, no high-end is rolled-off.

Using Insert Effects

To insert an effect on Input Channel 1 and/or 2:
Press the INSERT FX•COSM button so it lights—
1
thus turning on the insert effect—and select
the desired effect, as described earlier.
Press the channel's INSERT FX button so it stays
2
depressed.
Press the INSERT FX•COSM button to return to
3
the INS screen where you can adjust the effect's
settings as desired.
Power Cmp1
This compressor simulates the effect of a vaccum-tube amp, and is good for
beefing-up electric guitars and basses.
Parameter: This parameter
NS sets the threshold below which unwanted
range: -90 to -440dB quieter sounds are reduced in volume to
generate a cleaner signal.
BASS adjusts the level of the signal's low-
range: 0-100 frequency content. A setting of 50 leaves
it in its original state.
TUBE sets the amount of vacuum tube-like
range: 0-100 distortion applied to the signal.
COMP sets the amount of compression applied by
range: 0-100 lowering the level threshold above which
signals are compressed, and at the same
time raising the overall level of the signal
as you increase the parameter's value.
6