Table of Contents
Advertisement
El
Remove the cooktop from
the cutout and place it
'
upside down on a
protected surface.
Remove the paper backing from a
small section of the foam sealing strip. Place the
strip l/8" from cooktop edge on the underside of
the glass. Continue until foam strip completely
outlines the edge of the cooktop.
If you are installing more than one cooktop in the
same cutout, you do not need to place a foam
strip on the side that will be adjacent to another
cooktop.
Do Not use additional sealant around outer edge
of cooktop(
151
Attach mounting brackets
.
to each side of the
burner box with the 5/16"
screws. Do Not tighten the screws.
Turn the mounting brackets so
each is under the burner box. If
you are installing a second
cooktop in the same cutout, attach one mounting
bracket to the outside edge only.
El
Insert the cooktop into the cutout and
.
align it with the pencil line. Check that
cooktop is parallel to the front edge of
the countertop.
Lift the entire cooktop to make
adjustments so the foam sealing strip can seal
properly.
If you are installing
only one cooktop
in
cutout,
go to Step 8.
If you are installing
a second
gas cooktop
in
the same cutout,
complete Steps 1, 2, 4, 5, 6
and 7.
F'\\Q
,support
brace
screws
171
Attach support brace to side of the
.
cooktop that will be adjacent to another
cooktop. Insert second cooktop into the
cutout
and align with the pencil line used for first
cooktop. Check that cooktop is parallel to the
front edge of the countertop. Lift the entire
cooktop to make adjustments so the foam
sealing strip can seal properly.
glass cooktop,
countertop
bracket
screw
18.1
One cooktop
in cutout:
Rotate the
mounting brackets away from the burner
box. Do Not overtighten
screws.
Tighten the mounting brackets to the burner box.
Insert the 2-l/2" clamping screws into the
mounting brackets. Use a screwdriver to tighten
the screws against the underside of the
countertop. Remove the pencil outline from
countertop.
Two cooktops
in cutout:
Rotate the left
mounting bracket away from the burner box of
the first cooktop. Tighten the mounting bracket
to the burner box. Insert the 2-l/2" clamping
screw into the mounting bracket. Use a
screwdriver
to tighten the screw against the
underside of the countertop.
Rotate right mounting bracket away from the
burner box of the first cooktop. Attach other end
of mounting bracket to second cooktop with a
5/l 6" screw. Use a screwdriver
to tighten
mounting bracket to both cooktop.
Rotate mounting bracket of the second cooktop
that will be adjacent to the right side of the cutout
away from the burner box. Tighten the mounting
bracket to the burner box. Insert the 2-l/2"
clamping screw into the mounting bracket. Use a
screwdriver
to tighten the screw against the
underside of the countertop.
Remove the pencil outline from countertop.
Install the pressure regulator with the
arrow on the regulator pointing up
toward unit and in a position where you
can reach the access cap.
6
Advertisement
Table of Contents
