Mounting And Plugging In The Camera; Plugging Camera In - Uniden UWG700 Owner's Manual

Mounting and Plugging in the Camera

Using the AC adaptor is the recommended method of powering the Camera. The placement of the camera
should be within reach of a power point.
Note: The camera can also operate in a limited capacity using batteries.
Note: The camera is NOT WATERPROOF. The camera's front housing is weatherproof when mounted
correctly, DO NOT expose it to excessive water or moisture.

Plugging Camera In

1. Unscrew and remove the small backing on the lower back of the
camera.
2. Pull the black and red wires through the hole on the plug located
on the small backing.
3. Pull the black and red wires through the provided wire holes on any
of the mounts you are using, starting with the flat mount first.
4. Using a flat head screw driver, loosen the screws for the positive
and negative connection, next to the words DC (first and second
connection).
5. Insert the black wire into the slot to the negative connection (first
slot) and the red wire into the positive connection (second slot).
6. Tighten the screws for the negative and positive connection (first
and second slot). Tightening the screws will lock the wires into
place.
7. Pull gently on the wires to ensure they are locked into the proper
slots.
8. Plug the other end of the red and black wire into the provided
power adapter.
9. Plug the power adapter into a power source.
10. Before putting the backing on, check that the camera and monitor
are paired (See Pairing Camera and Monitor p.19).
8
Loosen screws for Positive
and Negative Connection
When the wires are in proper
slots, tighten screws