Toshiba RAV-SM2242DT-E Service Manual page 105

No. Part name
1 Fan <Fan motor>
assembly
1) Take off screws (Arrow mark indicating
(Continued)
position) of the tightening band and then
remove the tightening band, the fixing bracket
and the fan motor.
2) Cut the bundling band (2 positions) that fix the
protective tube (white) on the relay connector
of the fan motor.
3) Remove the fan motor lead wire assembly and
the protective tube from lead wire of the fan
motor.
4) Mount the fan motor lead wire assembly and
the protective tube to the fan motor to be
replaced, arrange the tube so that it covers the
relay connector and then fix it with bundling
band (2 positions).
5) Put the fan motor to be replaced on the motor
base.
Set the fan motor so that label of the model
name is at upper side when replaced.
∗ After replacement, assemble the fan motor in
Motor base
Work procedure
reverse order so that it becomes the same
status as that before replacement.
Be careful there is no loosening of screws
when assembling.
Check also that there is no fitting of fan with
fan case, no air discharge and no abnormal
sound
Fixing bracket
Protective tube Protective tube Protective tube
Fan motor
Tightening band
(Left): 2 pcs.
(Right): 2 pcs.
– 105 –
Remarks
1) 1) 1)
1) 1) 1)
Tightening band Tightening band Tightening band
(Ø4: 1 position for left/right each) (Ø4: 1 position for left/right each) 4: 1 position for left/right each)
2), 3) 2), 3) 2), 3)
Relay connector Relay connector Relay connector
Fan motor lead wire Fan motor lead wire Fan motor lead wire
Fan motor lead Fan motor lead Fan motor lead
wire assembly wire assembly wire assembly
Fix the both ends of the Fix the both ends of the Fix the both ends of the
protective tube so that it protective tube so that it protective tube so that it
covers the relay connector section. covers the relay connector section. covers the relay connector section.
4) 4) 4)
5) 5) 5)
Fan motor model name label Fan motor model name label Fan motor model name label