4 Replacement Procedures
4.22 Fan/Heat sink/CPU
Removing the Fan/Heat sink/CPU
The following describes the procedure for removing the fan/heat sink/CPU. (See Figure 4-34
to 4-36.)
1. Peel off the glass tape and disconnect the fan cable from the connector CN8771 on
the system board.
2. Remove the following screws securing the CPU hold plate in the reverse order of the
number marked (3 to 1) on the CPU hold plate and remove the CPU hold plate.
• M2×4B
3. Remove the fan and heat sink.
4-52
[CONFIDENTIAL]
BIND screw
CPU hold plate
M2x4B BIND
Glass tape
Fan cable
Figure 4-34 Removing the fan/heat sink
Satellite R20/TECRA M7 Maintenance Manual (960-572)
4.22 Fan/Heat sink/CPU
×3
M2x4B BIND
Fan
Heat sink
CN8771