Audiovox VODDLX10 Installation Manual page 8

The trim ring is attached to the video monitor using the perimeter screw bosses. It is important that the screws used in this installation are not over
tightened, and that the video monitor and trim ring are mounted in such a way that the assembly does not distort (or bend) when the mounting
screws are tightened.
There are two Trim Ring options for mounting the VODDLX1 0, one is to use the supplied Trim Ring for all vehicles with flat headliner mounting
areas (no contour) or a thick Trim Ring (not supplied) that can be cut to fit the contour of a headliner that is not flat (see Appendix B of this manual)
NOTE: The trim rings supplied with this unit are not designed to be trimmed.
Installing the Trim Ring
1. Turn the DVD Player over on a surface with protective covering to prevent scratches.
(A)
(A)
2. Using a screwdriver, remove the three screws located in the "A;' locations shown in the figure above. These screws can be discarded as new
screws are supplied in the hardware kit.
3. Place the trim ring onto the DVD Player.
7