Duracell Powerpack 300 Owner's Manual page 42

Problem
Battery Status LED is red
and has not changed to
green after 24 hours of
charging.
The engine being
jumpstarted will not start.
The jump-start clamps
measure zero volts.
The compressor runs, but
won't infl ate.
Possible Cause
The voltage at the AC wall
outlet is less than 120
VAC.
Use AC wall outlet that
supplies 120 VAC.
®
Duracell Powerpack
battery is not fully
charged.
The engine condition is
poor.
The engine start capacity
exceeds the Duracell
Powerpack jump-start
capability.
Jump-start power switch
is OFF.
®
Duracell Powerpack
battery needs to be
recharged.
The valve connector may
not be securely placed on
the valve stem.
The item being infl ated
may have a leak.
31
Solution
Continue to charge the unit
for another 12 hours; the unit
will be ready to use even if the
Battery Status light remains
red.
Recharge the Duracell
Powerpack battery.
Have the engine serviced.
Use a higher power Duracell
®
Powerpack.
Turn the jump-start power
switch ON.
Recharge the battery.
Make sure the valve connector
is securely placed on the valve
stem before closing the thumb
latch.
Make sure the item being
infl ated doesn't have a leak.
Check the compressor hose for
any breaks or leaks.
®
®