Table of Contents
Advertisement
Quick Links
XPower Inverter 150, 300 & 500
Portable AC power from the battery in your vehicle
Ideal for powering recreational, mobile office equipment and other electronic appliances, XPower Inverters
convert 12 volts of DC battery power in your vehicle to 230 volts of AC power. Available in a range of
sizes, the inverters can power a variety of electronic products including TVs, VCRs, fax machines, laptop
computers, camcorders, stereos, small power tools and work lights.
Choosing the right size of inverter for a particular application is important. For example, the XPower 150
Inverter can run a laptop for approximately 9 hours from a 75-amp hour battery; the XPower 300 can run a
49 cm TV for approximately 6 hours from a 75-amp hour battery. The exact run time depends on the amount
of power being drawn by the application and the size and condition of the battery. The XPower Inverter 500
can be used instead of a generator for low power or intermitent loads.
Product Features
Available in 150, 300 or 500 watt models
Offer 300, 600 or 1000 watt surge capacity
Available in three AC outlet configurations: Schuko, UK and AUS/NZ
Regulated output protects sensitive equipment
Compact size for convenient use and storage
Auto shutdown prevents total battery discharge
Silent operation
Mounting brackets for convenient installation (XPower Inverter 300 and 500)
Protection Features
Over temperature shutdown
Overload shutdown
Low voltage shutdown (at 10.0 VDC)
Over voltage shutdown (at 15.0 VDC)
Low voltage alarm (at 10.7 VDC)
Short circuit protection
Battery reverse polarity (fuse protected)
LED indicator confirms fault connection
© 2004 Xantrex Technology Inc. All rights reserved. Xantrex is a registered trademark of Xantrex International. Printed in Canada
12 VDC to 230 VDC /50 Hz Power Inverters
Xantrex Technology Inc.
Headquarters
8999 Nelson Way
Burnaby, British Columbia
Canada V5A 4B5
800 670 0707 Toll Free
604 420 1591 Fax
5916 195th Street NE
Arlington, Washington
USA 98223
800 446 6180 Toll Free
360 925 5144 Fax
www.xantrex.com
Advertisement
Table of Contents
Related Manuals for XPower 150
Summary of Contents for XPower 150
-
Page 1: Product Features
Choosing the right size of inverter for a particular application is important. For example, the XPower 150 Inverter can run a laptop for approximately 9 hours from a 75-amp hour battery; the XPower 300 can run a 49 cm TV for approximately 6 hours from a 75-amp hour battery. The exact run time depends on the amount of power being drawn by the application and the size and condition of the battery. -
Page 2: Electrical Specifications
XPower Inverter 150, 300 & 500 12 VDC to 230 VDC /50 Hz Power Inverters Electrical Specifications Models Output power (continuous) 150 W 300 W 500 W Surge capacity (peak) 300 W 600 W 1000 W Output voltage 230 VAC +/- 5%... - Page 3 XPower Inverter 300 Owner’s Guide...
-
Page 4: Contact Information
Trademarks XPower is a trademark of Xantrex International. Xantrex is a registered trademark of Xantrex International. Other trademarks, registered trademarks, and product names are the property of their respective owners and are used herein for identification purposes only. -
Page 5: Table Of Contents
AC Outlets ....... . . 8 4. Connecting the XPower 300 ....9 Choosing a Location . -
Page 7: Introduction
Connected to the 12 volt outlet in your vehicle or directly to your battery for loads over 150 watts, the XPower 300 efficiently and reliably powers a wide variety of household AC products, such as TVs and VCRs, laptop computers, camcorder and cell phone chargers, compact fluorescent lights, and soldering irons. -
Page 8: Important Safety Information
AC outlet or any other openings in the inverter. Do not open the inverter. Have a qualified individual complete any service work. WARNING: Shock hazard Do not expose the XPower 300 to water, rain, snow, or spray. - Page 9 WARNING: Fire hazard To reduce the risk of fire, do not cover or obstruct the ventilation openings. Do not install the XPower 300 in a zero-clearance compartment. Overheating may result. WARNING: Shock and fire hazard During installation route all cable/wiring away from sharp edges and hot surfaces of the engine compartment or vehicle.
- Page 10 CAUTION: Risk of damage to equipment The XPower 300 is designed to be directly connected to standard electrical and electronic equipment in the manner described in this guide. Do not connect it to household or RV AC distribution wiring. Do not connect it to any AC...
- Page 11 These chargers have a warning label stating that dangerous voltages are present at the charger battery terminals. Do not use the XPower 300 with the type of appliances just described. CAUTION: Risk of damage due to high temperatures Do not use the XPower 300 in temperatures over 40°...
-
Page 12: Xpower 300 Inverter Features
An AC outlet is located on one end of the inverter. It allows you to plug in a 230 volt AC product with a power consumption of 150 watts or less when the inverter is operated from a vehicle lighter socket, or 300 watts or less when it is connected directly to a battery. - Page 13 When the inverter is connected to a DC power source and the On/Standby switch is on, AC power is available at the outlet. Power Light The green light is on all the time when the On/Standby switch is on. Fault Light The red light indicates that the inverter has shut down because of low or high battery voltage, AC overload, or excessively high temperatures.
-
Page 14: Ac Outlets
AC Outlets Depending on your geographic location, your XPower 300 will have one of the following AC outlets. Figure 3 British AC Outlet Figure 2 European AC Outlet Figure 4 Australian and New Zealand AC Outlet... -
Page 15: Connecting The Xpower 300
4 Connecting the XPower 300 This section explains how to connect the XPower 300. Choosing a Location For the best performance, choose a location that is: • Dry Do not expose the inverter to water drip or spray. • Cool Operate the inverter in ambient temperatures between 0°... -
Page 16: Connecting The Xpower 300 To Dc Power
Connecting the XPower 300 to DC Power CAUTION: Risk of damage to the XPower The XPower 300 must only be operated with a nominal 12 volt battery. The inverter will not operate with a lower voltage battery. A higher voltage battery will damage the inverter. -
Page 17: Using The Cigarette Plug Wire Assembly
150 watts: they will overheat and present a fire hazard. Do not use loads greater than 150 watts with the cigarette plug wire assembly. Loads under 150 watts When you are going to power loads under 150 watts, use the cigarette plug wire assembly. -
Page 18: Using The Battery Clip Wire Assembly
Using the Battery Clip Wire Assembly Loads greater than 150 watts When you are going to power loads that are greater than 150 watts (up to 300 watts continuous power), connect the inverter to a 12 volt battery using the battery clip wire assembly. - Page 19 CAUTION: Risk of damage to the XPower Reversing the positive and negative battery cables will damage the inverter and void your warranty. When you connect the inverter to the battery, double check the connections. The red wire must be connected to the red (+) terminal on the inverter and the positive (+) terminal on the battery.
-
Page 20: Hardwiring The Inverter To The Battery
For a permanent electrical connection, or when you need to power some loads that are greater than 150 watts and some that are less than 150 watts, you can hardwire the inverter to the battery. This eliminates the need to switch between the battery clip wire assembly and the cigarette plug wire assembly. - Page 21 WARNING: Fire hazard The wires in most 12 volt sockets or power outlets are not large enough for loads greater than 150 watts: they will overheat and present a fire hazard. For loads greater than 150 watts, connect the inverter...
- Page 22 To hardwire the inverter to the battery: Cut the clips off the cable clip wire assembly. (The wires in this assembly are appropriate for loads over 150 watts. The wires in the cigarette plug wire assembly are too small: do not use them.) Using 3.3mm...
- Page 23 CAUTION: Risk of damage to the XPower Reversing the positive and negative battery cables will damage the inverter and will void your warranty. Before connecting the inverter to the battery, double check the connections: the red wire must be connected to the red terminal on the inverter and the positive (+) terminal on the battery;...
-
Page 24: Disconnecting The Battery
Disconnecting the Battery • Before you disconnect the battery, turn off the AC load, and then turn off the in-line switch. Replacing the In-Line Fuse • If you need to replace the in-line fuse (see Figure 6), turn off the in-line switch to disconnect the DC power. -
Page 25: Operating The Xpower 300
• Possible shutdown when the vehicle’s engine is started The XPower 300 will operate while your vehicle’s engine is running, but the normal voltage drop... - Page 26 • AC Overload Shutdown If you connect an AC load rated higher than 300 watts or 1.3 amps or that draws excessive surge power, the XPower 300 shuts down. light stays on, and the light comes on to indicate that the inverter is overloaded.
-
Page 27: Interference With Electronic Equipment
Interference With Electronic Equipment Most AC products operate with the XPower 300 as they would with household AC power with the following exceptions. Buzzing Sound Some inexpensive stereo systems and “boom boxes” have inadequate internal power supply filtering and buzz slightly when powered by the XPower 300. -
Page 28: Battery Operating Time
• Do not leave the XPower 300 on for more than a week if you do not have an AC load connected to it. The inverter draws less than 0.2 amps with the On/ Standby switch on and no load connected, but that will eventually discharge the battery. -
Page 29: Troubleshooting
7 Troubleshooting WARNING: Shock hazard Do not open the inverter or attempt to service it yourself. Refer all service to qualified personnel. This section describes problems you may encounter, the symptoms of each problem, possible causes, and various remedies. The AC load will not operate; the red light is on. - Page 30 The battery is discharged. Recharge the battery. The battery voltage is Check the charging system. excessive. The AC load exceeds the 150 Connect the inverter directly to watt rating for the lighter the battery. See “Using the socket. Battery Clip Wire Assembly”...
- Page 31 The AC load will not operate; no inverter lights are on. Symptom The cigarette lighter works in the lighter socket, but the inverter does not. Possible cause Suggested remedy The contact between the plug Press the plug firmly into the and the lighter socket or the 12 socket.
- Page 32 Symptom The AC voltmeter reading is 5 to 15 volts too low. Possible cause Suggested remedy A standard “average-reading” For accuracy, the XPower 300 AC voltmeter has been used to modified sine wave output measure output voltage. needs to be measured with a “true RMS”...
-
Page 33: Specifications
8 Specifications Specifications may change without notice. Electrical AC receptacles AC output voltage 230 volts AC RMS ± 5% AC output frequency 50 ± 3 Hz AC output waveform Modified Sine Wave Maximum continuous AC output 300 watts power Maximum AC output surge power 600 watts DC input voltage range 10–15 volts DC... -
Page 34: Physical
Physical Dimensions (L x W x H) 200mm x 103mm x 66mm (7.9 in. x 4.1 in. x 2.6 in.) Weight 0.79 Kg (1.74 lb.) Regulatory CE Mark Low Voltage Directive e Mark Automotive EMC Directive TUV/Type approved Certified to EN60950 Environmental Complies with the EU’s “Restriction of Hazardous Substances”... -
Page 35: Product Recycling
Product Recycling Do not dispose of this product with general household waste! Electrical appliances marked with the symbol shown must be professionally treated to recover, reuse, and recycle materials, in order to reduce negative environmental impact. When the product is no longer usable, the consumer is legally obligated to ensure that it is collected separately under the local electronics recycling and treatment scheme. -
Page 36: Limited Warranty
What does this warranty cover? This Limited Warranty is provided by Xantrex Technology, Inc. ("Xantrex") and covers defects in workmanship and materials in your XPower Inverter 300. This warranty period lasts for twenty-four (24) months from the date of purchase at the point of sale to you, the original end user customer. - Page 37 How do you get service? If your product requires troubleshooting or warranty service, contact your merchant. If you are unable to contact your merchant, or the merchant is unable to provide service, contact Xantrex directly at: Telephone: 1 360 925 5097 (direct) Fax: 1 360 925 5143 (direct) Email:...
- Page 38 What does this warranty not cover? This Limited Warranty does not cover normal wear and tear of the product or costs related to the removal, installation, or troubleshooting of the customer's electrical systems. This warranty does not apply to and Xantrex will not be responsible for any defect in or damage to: the product if it has been misused, neglected, improperly installed, physically damaged or altered, either internally or...
- Page 39 RESTRICTION ANY IMPLIED WARRANTY OR CONDITION OF QUALITY, MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE TO THE EXTENT REQUIRED UNDER APPLICABLE LAW TO APPLY TO THE PRODUCT SHALL BE LIMITED IN DURATION TO THE PERIOD STIPULATED UNDER THIS LIMITED WARRANTY.
-
Page 40: Return Material Authorization Policy
IN CONNECTION WITH LIFE SUPPORT SYSTEMS OR OTHER MEDICAL EQUIPMENT OR DEVICES. Please note that the XPower Inverter 300 is not intended for use as an uninterruptible power supply and Xantrex makes no warranty or representation in connection with any use of the product for such purposes. -
Page 41: Return Procedure
Return Procedure Package the unit safely, preferably using the original box and packing materials. Please ensure that your product is shipped fully insured in the original packaging or equivalent. This warranty will not apply where the product is damaged due to improper packaging. -
Page 42: Other Xantrex Products
Out of Warranty Service If the warranty period for your XPower Inverter 300 has expired, if the unit was damaged by misuse or incorrect installation, if other conditions of the warranty have not been met, or if no dated proof of purchase is available, your inverter may be serviced or replaced for a flat fee.