Jensen JCD3010 Installation And Operation Manual page 4

WIRING
ACCESSORY/IGNITION (+)
Connect to existing radio accessory fuse or
+12 VDC switched power source.
POWER ANTENNA
Connect to power antenna or amplifier. If not
used, tape bare end of wire.
A - A
Wire Connector
MEMORY/BATTERY (+)
Connect to battery or 12 volt power source
that is always live. The radio will not work if
this wire is not connected.
GROUND
Connect to ground terminal or clean,
unpainted metal part of chassis.
4
A- A
SHOWN FROM PIN VIEW
15A FUSE
JCD3010