Table of Contents
Advertisement
When you are finished using the grinder and it has cooled, you must:
o Cool engine before storage.
o Clean the grinder.
o Inspect for worn or damaged parts.
o Choose covered storage location.
o Prevent accidental starting.
o Plan on exercising the engine at least monthly unless the grinder is prepared for long-term
storage.
Detailed instructions are provided below
Cool engine
Clean grinder
Inspect grinder
Choose a storage
location
Remove key
Start grinder every
4 weeks
Operation (cont'd)
6. Storing the Grinder
.
Let engine cool for at least five minutes before storing. A hot engine can
be a fire hazard.
Clean all grease, dirt, mud and other foreign matter from the machine.
Touch up paint damage to prevent rust.
Inspect the machine for worn or damaged parts and tighten any nuts or
screws that may have become loose. Pay particular attention to the
cutting teeth.
Store the grinder in a location that is:
o Clean and dry
o Away from sources of heat, open flames, sparks, or pilot lights, even
if the grinder's gas tank is empty. Residual gasoline could ignite.
o Away from extreme high or low temperatures.
o Cover it for extra protection
Remove key from starter and secure key in a safe location, or remove
spark plug, in order to ensure the grinder cannot be started in a storage
location or by untrained persons or children.
The grinder should be started regularly. At least every four weeks, start
the engine and let it run for 10 to 15 minutes.
Monthly exercising of the grinder will dry out any moisture that has
accumulated, lubricate cylinders, and clean out old gas in the carburetor.
Moisture, old gas, and dry mechanical parts cause deterioration in stored
engines.
16
Advertisement
Table of Contents
