DeWalt DW735 Instruction Manual page 15

2. Secure the rear of the planer to the table/bench with nails or
screws to prevent it from tilting or falling from the table.
WARNING: The planer could tilt or fall from the table if it is not
properly secured opposite the end where the folding table is being
installed. Serious injury may result.
3. Place the spring onto the small end of the stepped Allen bolt.
4. Insert the end of the bolt with the spring around it into the larg-
er hole on the side of the base.
5. Push the stepped Allen bolt all the way through the hole in the
first rib on the underside of the planer. The spring should
engage the rib slightly and the threads should show on the
right side of the rib.
6. On the underside of the planer,
use a wrench to hold the nut in
place while turning the stepped
bolt into it. The T-wrench on your
planer can be used to turn the
stepped bolt until it is fully
secured (Fig. 7).
7. Install the smaller Allen screw
into the lower threaded hole
on the side of the base. Use
the T-wrench to tighten that fas-
tener securely (Fig. 8).
8. Depress the top Allen pin until it is flush with the base and slide
the top hole of the table over the pin and release the pin so
they lock together (Fig. 8, 9).
9. To attach the table to the rear of the planer, install the bolts and
spring following the above procedure.
Your tables should now fold up and down on the top Allen screw
and rest on the bottom screw while in position for planing.
NOTE: To transport the planer with the tables, fold them up and
carry the unit as recommended by the planer manual.
people carry this machine or serious injury could result.
FIG. 7
TO REMOVE THE TABLES
1. Depress the spring-loaded bolts on the base and slide each
2. Leave the hardware (stepped bolts and small Allen cap screw)
Repairs
To assure product SAFETY and RELIABILITY, repairs, mainte-
nance and adjustment should be performed by authorized service
centers or other qualified service personnel. Always use identical
replacement parts.
Full Warranty
D WALT heavy duty industrial tools are warranted for one year
E
from date of purchase. We will repair, without charge, any defects
due to faulty materials or workmanship. For warranty repair infor-
mation, call 1-800-4-D
12
FIG. 8
WARNING: For your own safety, it is recommended that two
end of the table toward you so they disengage the holes in the
tables. You may want to use the T-wrench from your planer to
push the bolts flush with the base to easily remove the tables.
in the base until you need to re-attach the tables.
WALT. This warranty does not apply to
E
FIG. 9