Clock Settings; Radio Operations - Jensen JiMS-60 Owner's Manual

11. FM ANTENNA
When you plug the radio to an AC outlet for the first time the clock display will
begin flashing "12:00". The flashing will stop when you set the time.
1. In standby mode, press and hold the TIME SET button and repeatedly press
the HOUR button to set the correct Hour.
2. Press and hold the TIME SET button and repeatedly press the MINUTE
button to set the correct Minute.
NOTE
There is a PM indicator located in the top left-hand corner of the clock display.
Be sure to observe the PM indicator when setting the time to make sure the time
is set correctly for AM or PM. If the PM indicator is 'On', the time displayed is
"PM". If the PM indicator is 'Off, the time displayed is "AM ".
1. Press the ON/STANDBY button to turn the unit on.
2. Slide the FUNCTION selector to the desired radio band, AM or FM.
3. Select your desired station with the TUNING control.
4. Adjust the VOLUME control to the desired listening level.
5. When you have finished listening, press the ON/STANDBY button to turn
the radio off.
TIPS FOR BEST RADIO RECEPTION
AM - The AM antenna is built inside the radio. If AM reception is weak, slightly
rotate or change the position of the unit until the internal antenna picks up
the strongest signal.
FM - If FM reception is weak, fully extend the wire antenna and vary the position
and location of the antenna until you find the strongest signal.
Note: To avoid any interference noise generate from speaker, please do
not put any iPod models near the system while listening to AM
radio.
22. SLEEP INDICATOR

CLOCK SETTINGS

RADIO OPERATIONS

7