Table of Contents
Advertisement
SWP-0412G2 Series L2 Web Smart Switch User Guide
Command Description
These are the group commands of the command line interface:
Command groups:
System
- System commands
Console
- Console commands
Port
- Port commands
VLAN
- VLAN commands
Aggr
- Aggregation commands
QoS
- QoS commands
Mirror
- Mirror commands
IP
- IP commands
SNMP
- SNMP commands
Ratelimit
- Rate setup commands
Exit
- Logout commands
System Commands
Commands at System level:
System Configuration [all]
System Restore Default [keepIP]
System UserName [<name>]
System Password [<password>]
System Systemname [<name>]
System Reboot
System Configuration [all]
Syntax:
System Configuration [all]
Description:
Show system name, username, password, software version and management MAC
address. Optionally show the full configuration
[all]: Show the total switch configuration (default: System configuration only)
System Restore Default [keepIP]
Description:
Restore factory default configuration.
[keepIP]: Preserve IP configuration (default: Not preserved).
UserName [<name>]
Description:
Set or show the user name.
[<name>]: String of up to 16 characters (default: Show user name).
System Password [<password>]
Description:
Set or show the console password. The empty string ("") disables the
password check.
[<password>]: Password string of up to 16 characters.
System Systemname [<name>]
Description:
Set or show the system name.
30
Advertisement
Table of Contents
