Contents subject to change without prior notice. °¥ Do not use attachments not recommended by the product manufacturer as Pci is a registered trademark of PLANEX COMMUNICATIONS INC. they may cause hazards. All other trademarks belong to their respective proprietors.
Helps you get started with the basic installation of the hub and tells how you can connect they may touch dangerous voltage points or short out parts that could result in the EH-505P/805P to your Ethernet network. a fire or electric shock. Never spill liquid of any kind of the product.
Page 5
Packing List ............. Parts Terminology ........... Front Pane l ............Rear Panel ............Bottom Side ............Chapter 2 Installation Set up ..............Power On ............Connection PC to EH-505P/805P ....Cascading EH-505P/805P to Another Hub .. Appendix A Specifications ............
Each port has a status LED indicator that monitors the conditions of the hubs. Packing List The magnets at the base of the unit let you install EH-505P/805P easily on Open the shipping carton of the hub and carefully unpack its contents. The steel desks and cabinets.
Page 7
Parts Terminology Bottom °Ω °∞ °¥ Magnet For installation on steel desks. The figure shows the design of EH-805P.EH-505P has the same design as EH-805P’s except for the number of ports. °¶ °Ω Front Panel °¥ PWR LED Lights up when the hub s power is turned on.
Chapter 2 Installation EH-505P/805P Set up Power On There are two magnets each at the bases for easy installation on steel desks 1. Plug the power cable of the AC adaptor into the power connector on the or cabinets. The magnets are removable. To remove a magnet, insert a rear panel.
Page 9
EH-505P/805P EH-505P/805P Connection using RJ-45 port Hub to PC Cascading EH-505P/805P to Another Hub °¥ Plug one end of a twisted-pair cable into an Uplink port of Plug one end of a twisted-pair cable into a RJ-45 port of EH- EH- 505P/805P.
Appendix A Specifications EH-505P/805P 3. When using crossover cable, use any (MDI-X) port of the hub and any of EH-505P the 10 Mbps or 100 Mbps (MDI-X) ports of the other hub or other Standards : IEEE 802.3, 10BASE-T devices.
Need help?
Do you have a question about the EH-505P and is the answer not in the manual?
Questions and answers