Safety Warnings - Peavey MediaMatrix NION Hardware Manual

Chapter 2 - Safety Instructions and safety warnings
So me text to force a page break in Word but remain invisible

Safety Warnings

The following cautions should be carefully observed when installing, wiring or using this
product:
10
To prevent electrical shock or potential fire hazards, do not expose this product to
moisture or rain.
Before using this product, read the user manuals for further warnings and cautions.
DO NOT use any other power supply or cable other than the one provided with this
unit.
DO NOT remove the top cover of the unit. There are no user-serviceable parts
inside. Refer service to qualified personnel.
DO NOT use solvents or other cleaners to clean the unit. Basic external care requires
only a damp cloth. Disconnect the power supply cord before cleaning.
Read all safety and installation instructions and retain all documentation for further
reference.
This product should not be installed or placed near a source of heat.
Power supply cords and associated connectors should be unplugged from the power
source when the unit is not used for long periods of time or stored.
This product is designed for EIA rack mounting only. Use racks of sufficient depth
and width to accommodate proper airflow and cable harnessing.
Care should be taken to ensure that the installation is clear of possible sources of
contamination. Make sure that the product's ventilation openings are not exposed to
possible sources of liquid, gases, or other contaminants.
This product should be inspected by a qualified service technician if the power
supply cord or connector has been damaged, if the unit has been dropped, or if a
foreign substance has gained access to the interior electronic and electrical
components.
When dressing off wiring harnesses, take care with CAT 5 cables. Do not tie-wrap
bundles of CAT 5 wire too tight. Leave plenty of room for bends, allowing the cable
to progress naturally from the RJ-45 connector. Creating tightly wrapped CAT 5
wire bundles can cause data transmission errors.
Version 1.6.1.0 September 30, 2010