Easystand Glider Assembly - EasyStand Glider Owner's Manual

®

EasyStand Glider Assembly

®
Videos on EasyStand assembly & fitting can be viewed at www.easystand.com/videos
FIG . 1- For International orders only: Attach the front caster
frame to the front frame with bolts and tighten securely.
FIG . 2- Attach the casters to the rear base frame. Tighten
securely using the provided wrench. Ensure the casters are
flush with the rear base frame. The casters are supplied with
a locking compound pre-applied to the threaded stem. Do not
remove this material, it is important to prevent the casters
from loosening over time.
FIG . 3- Place the front frame and the seat assembly on its
side, slide the front frame into the opening of the seat assem-
bly as shown. Line up holes and insert all four bolts first, then
place nuts onto bolts and tighten securely with hex wrench
and 19mm open-ended wrench. Place unit upright on its
wheels.
FIG . 4- Remove the ratchet handles and bolts from the glide
FIG. 4
handles, slide the glide handles into the slots. Tighten secure-
ly. If any additional options were ordered, please refer to the
drawings on pp. 5-10. Install the seat onto the seat assembly
after all other options are added.
Seat Assembly
FIG. 1
FIG. 3
FIG. 2
Front Frame
Page 3 - Assembly