Adjusting Your Glider - EasyStand Glider Owner's Manual

Adjusting Your Glider

Seat Depth/Back Angle
!
Caution: These adjustments are only to be made while the unit is in
the seated position.
FIG . 11- Loosen the knob on the seat tube located under the seat. Do
not unscrew seat depth knob all the way when adjusting the seat.
Depress the spring button and position the back so that the hip pivot
is located as close as possible to the user's hips. Tighten the seat
depth knob securely.
Note: Adjust back angle after each seat depth position change.
FIG . 12- To adjust the back angle, use the knob located on the
following arm. Before standing, the back angle must be set so the
indicator on the side of the unit is in the green.
FIG . 13- The back/seat angle locator is located on the side of the unit.
When the unit is in the seated position, the green area indicates the
back angle. Before standing, the indicator must be in the green.
!
Caution: Before standing, the seat/back angle indicator must be in the
green. Failure to set the back angle in green prior to standing could
cause the unit to lock in a standing position, causing damage to your
unit.
Tray/Front Pad
FIG . 14- To adjust the height of the tray/front pad, loosen the clamp
located just above the front column. Lift the tray to the user's desired
height level and tighten the clamp.
To adjust the depth of the tray/front pad, loosen the clamp located
just below the tray. Move the front pad to the user's desired position
and tighten the clamp.
!
Caution: While lowering the tray height, keep hands clear of the area
underneath the tray.
®
FIG. 11
FIG. 12
Green Area
FIG. 13
FIG. 14
Adjusting - Page 16