Tiffin Motorhomes 2015 Allegro Owner's Manual page 48

5. If the water heater fails to operate because of high water temperature, the heater will go into a
lockout condition (indicator light "on"). When the water eventually cools, reset the system by turn
ing the switch to the "off " position for at least 30 seconds, then turn the switch back "on. "
6. If a lockout condition persists, contact your authorized dealer.
120-Volt AC Electrical Operation
1. For electrical operation, use the Water Heater switch found on the master control panel in the
overhead compartment in the cockpit area above the passenger's-side location.
2. Completely fill the water heater with water and purge the hot-water lines of any trapped air.
3. Turn the Water Heater switch "on. " NOTE: Turning the power "on" to the water heater without
having previously covered the water-heating element with water may burn out the element and
void the warranty.
4. After awhile, check the water heater for proper operation; the water temperature should be approx
imately 140°F (60°C).
5. If the manual-reset, high-temperature-limit switch should trip the circuit breaker; reset the switch
by depressing the reset button--use a pencil or other non-metallic object to depress the reset but
ton. If the high-temperature-limit switch should again trip the circuit breaker, contact an autho
rized service technician or an authorized dealer.
6. Both the electrical and gas operations of the water heater may be used simultaneously to reduce
recovery time of heating water up to desired temperature.
For general maintenance of the water heater or specific information about select steps in operating the
water heater, please refer to the owner's manual for this appliance contained in the Owner's Informa-
tion Package.
DO NOT STORE any combustible or flammable substances near or adjacent
to the water heater. Provide adequate space for ventilation and air circula-
tion.
APPLIANCES & ACCESSORIES
W AR N ING
41