General Information; The Endurolife Belt; Lubrication; Wood Floors, Soft (Vinyl, Asphalt Tile, Etc.) - Oreck Forever Series Gold User Manual

General
Information
7
E N

The Endurolife Belt

The Oreck Gold is equipped with the Endurolife Belt, which is designed for long life and
doesn't need changing. If the vacuum sucks up a large obstruction, the Endurolife Belt is
designed to shut the upright down.
WARNING: Unplug cord from electrical outlet before servicing.
1. Clear any large obstruction or blockage from the vacuum.
2. Once the blockage is cleared, plug the vacuum back in and it will reset.
NOTE: If the vacuum continues to shut down, contact an Oreck Authorized
Service Center.

Lubrication

The vacuum motor bearings are factory lubricated and sealed. Further lubrication is not
required.
CAUTION

Wood Floors, Soft (Vinyl, Asphalt Tile, etc.)

Floor Surfaces and
Polished Floor Finishes
Use floor and floor finish manufacturer's recommended
methods of cleaning. The brushroll may also scuff very
soft finishes. Do not operate the vacuum while in the
upright and locked position. Do not let the vacuum run
while in any one stationary position for any period of
time. Keep the vacuum moving while in operation.
Note: At least once a month, check for and remove
excessive lint, string or hair from the revolving
brushroll. Patented cleaning grooves on the brushroll
will allow easier cleaning. Wipe the outside of the
vacuum with a damp cloth. Also clean the connector
deflector assembly area, base of vacuum and fan
housing area. If there is dust in the outer bag, vacuum it
or shake it out.
A little preventative maintenance will keep your Upright
vacuum looking new and will ensure continued cleaning
effectiveness.
G L I S H