Table of Contents
Advertisement
We always recommend
you have your Blaupunkt
DVD/MP3 player professionally
installed
but the installation
process is
often so easy that the average consumer
can achieve success with little trouble.
All operating
instructions
should be
followed.
Regardless
of person installing,
you should be sure to review the following
points before proceeding
with the
installation:
n
READ THE MANUAL!
Understanding
the product and installation
limitation
before lifting a screwdriver.
Follow
Instructions
-
n
POWER SOURCES
- Make sure to use operate only from the type of power source indicated
on the rear panel. For
products
intended
to operate from battery power, or other sources, refer to the operating
instructions.
Do not overload
the power source to prevent a risk of fire or electric shock.
w POWER LINES - An outside antenna system should not be located in the vicinity of overhead
power lines or other
electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna
system, extreme care should be taken to keep from touching
such power lines or circuits as contact with them might
be fatal.
n
POWER CABLE - Make sure to route power cables appropriately
so that they are not likely to be walked on or pinched
by items placed upon or against them, paying special attention to cords at plugs, convenience
receptacles,
and the
point where they exit from the product.
n
CLEANING
- Disconnect
this product from the power source before cleaning. Do not use liquid cleaners or aerosol
cleaners.
Use a damp cloth.
n
WATER & MOISTURE - Do not use this product near water.
n
ACCESSORIES
- Do not place this product on an unstable object.
Any mounting
of the product should follow the
manufacturer's
instructions,
and should use a mounting
accessory
recommended
by the manufacturer.
w LIGHTNING - During a lightning
storm, or when it is left unattended
and unused for long periods of time, unplug it from
the power source prevent damage to the product due to lightning and power-line
surges..
n
OBJECT & LIQUID ENTRY - Never push objects of any kind into this product and/or liquid entry to product could result
in a fire or electric shock.
n
SERVICING - Any attempt to service this product yourself as opening
or removing covers may expose you to
dangerous
voltage or other hazards.
n
DAMAGES
REQUIRING SERVICE - Disconnect
this product from the power source and refer servicing to qualified
service personnel
under the following
conditions;
a) Damage to the power cord or plug
b) Water damage
c) Product malfunction
or change in performance
d) If the product
has been dropped
H PART REPLACEMENT
- Make sure to use the replacement
parts specified and/or approved
by the manufacturer
to
prevent potential
fire, electric shock or other hazards.
Upon completion
of any service or repair, be sure to perform
safety checks by qualified
service personnel.
n
WEAR SAFETY GLASSES
AT ALL TIMES - Flying debris are always dangerous.
w PROTECT THE VEHICLE - Always disconnect
the negative battery cable before starting any kind of installation
work.
This prevents a possible high current electrical
short (potential
fires).
n
HEAT - Keep all products
away from nearby hot components
such as amplifiers,
radiators,
heat registers, stoves or
vehicle components
that heat up over time such as hoses, high current wires, and braking systems components.
Make sure to leave enough
room for ventilation
on openings
and slots to protect if from over-heating.
n
GIVE YOURSELF
LOTS OF TIME - Rushing to complete
an installation
nearly always ends up with problems.
n
WHILE DRIVING, KEEP EYES ON THE ROAD AND NOT ON THE MONITOR.
KEEP THE VOLUME
LOW.
i
Please record the model and serial number located at rear panel.
Model
No.
Serial No.
-3-
Advertisement
Table of Contents
