Table of Contents
Advertisement
A U D I O P H I L L E O 1 & 2
Solid ON for
Firmware upgrade mode initiated (displayed on ap1 after
10-20 seconds
firmware->update menu is entered or on ap2 when firmware file
detected in audio stream.
1.23 above
The table below lists all possible LED error codes. Because they are fatal errors, these
error codes are repeated indefinitely once they occur. Under normal usage these codes
should never occur. If you see these errors, please contact technical support.
Flashes
LLS
The computer is a not a high speed USB host. Please connect the
device to a high speed USB port
LLSS
Flash memory polling error
LLSSS
Flash erase error
LLSSSS
Flash write error
LLSSSSS
SPDIF buffer problem
LLSSSSSS
SPDIF interrupt problem
LLSL
SPDIF underflow
LLSSL
Menu Find ID problem
LLSSSL
No empty remote control set found
LLSSSSL
Problem rebooting device
LLSSSSSL
Serial number invalid
LLSLL
Power supply missing
LLSSLL
USB CRC error (audio buffer corruption)
Note
: The Audiophilleo1 may display the message "Waiting for computer" after being
plugged in. This means that the computer is not configuring the Audiophilleo1 in a
reasonable amount of time.
U S E R
M A N U A L
Meaning
18
Advertisement
Table of Contents
