Table of Contents
Advertisement
A U D I O P H I L L E O 1 & 2
If the computer is in a sleep state, then the LED will be permanently on. All status
messages start with one L flash. All error messages start with two L flashes. The table
below lists all possible LED status codes:
Flashes
LS
44.1Khz sample rate set
LSS
48hz sample rate set
LSSS
88.2hz sample rate set
LSSSS
96hz sample rate set
LSSSSS
176.4hz sample rate set
LSSSSSS
192hz sample rate set
LSL
Windows operating system detected (displayed after plugging in)
LSSL
Windows custom driver detected (displayed after plugging in)
LSSSL
Linux operating system detected (displayed after plugging in)
LSSSSL
Apple OSX operating system detected (displayed after plugging in)
Firmware upgrade codes (shown when playing firmware.wav)
LSLL
Firmware Updated (displayed after successful firmware upgrade
after the device reboots)
LSSLL
Firmware already up to date (displayed after successfully reading a
firmware file but determining that the same firmware is already
loaded and no upgrade is necessary)
LSSSLL
Firmware file is bad (displayed after the downloaded firmware file
is corrupt because the computer modified the audio stream too
much)
LSSSSLL
Firmware upgrade mode initiated (displayed on ap1 after
firmware->update menu is entered or on ap2 when firmware file
v1.22 or below
detected in audio stream.
U S E R
M A N U A L
Meaning
17
Advertisement
Table of Contents
