Operation - Manhattan 160858 User Manual

main power button (also on the rear panel of the subwoofer) to the on position. This allows
you to then use the more convenient power buttons on the front of the subwoofer and on the
remote control to turn the speaker system on and off.
6. With the audio source turned on and generating an audio signal, adjust the volume and bass
level of the speaker system to desired levels (adjusting the volume/audio output level on the
audio source as necessary). NOTE: If connecting to a computer, you may want to conduct a
sound card test. With the speakers properly connected and turned on, find the computer's
sound card in the device manager and begin the test. Each channel should be able to be
tested for sound and link. With the "test" window still open, turn up the volume on each channel
(speaker). Test sound should be audible: If not, check and deactivate the mute feature (press
the mute button once) and do the test again.

OperatiON

The following controls and indicators are located on the front panel of the subwoofer, with similar
controls available on the remote control (see Remote Control below).
• POWER — When the main power button (on the rear panel of the subwoofer; see Setup
Step 5) is in the on position, the ST_BY LED lights red, indicating that the controls are ready
for use. Press the power button on the front panel and the ST_BY LED lights blue or green
while all other LEDs also light.