Tecumseh LV148EA Operator's Manual page 10

DO NOT operate an electric starter for more than 5 seconds
each attempt.
5. Push starter button or turn ignition switch key to start
engine.
6. When engine starts, release starter button or ignition
switch key.
7. If engine fails to start after 3 attempts repeat steps 2
thru 6 and try again.
8. If engine does NOT start after following steps 1 thru 7,
contact your Authorized Tecumseh Servicing Dealer.
DO NOT attempt to start or troubleshoot this engine in
any other way.
II. Choke Only
1. To avoid carbon monoxide poisoning, be sure engine is
outdoors in a well-ventilated area.
2. Move engine throttle control to "CHOKE" or "START"
position, if present (see equipment manufacturer's
instructions). See Figures 12, 13 and 16 starting on
page 7. Afterward, continue reading instructions below.
If restarting a warm engine after a short shutdown, move
engine throttle control to "FAST" position instead of
"CHOKE" or "START" position. See Figures 12, 13 and 16
starting on page 7. Afterward, continue reading instructions
below.
3. Operate equipment control to release engine brake or
clutch, if present (see equipment manufacturer's
instructions). See Figure 12 on page 7. Afterward, con-
tinue reading instructions below.
DO NOT operate an electric starter for more than 5 seconds
each attempt.
4. Push starter button or turn ignition switch key to start
engine.
5. If engine fails to start after 3 attempts repeat steps 2
thru 4 and try again.
6. When engine starts:
a. Release starter button or ignition switch key.
b. Move engine throttle control to "FAST" position. See
Figures 12, 13 and 16 starting on page 7. Afterward,
continue reading instructions below.
c. Next, move engine throttle control to desired speed
in "RUN" range.
If engine starts but falters when engine throttle control is
moved to "FAST" position:
a. Move engine throttle control back to "CHOKE"
position. See Figures 12, 13 and 16 starting on
page 7. Afterward, continue reading instructions.
Page 8
NOTE
NOTE
NOTE
NOTES
Four-Cycle Engine • Vertical Crankshaft • Air-Cooled
2
1
1. Spark Plug Cap
2. Spark Plug Wire
3. Starter Cord Handle
4. Air Cleaner
5. Primer
6. Carburetor
7. Muffler
Figure 15. Engine Components
1. "SLOW" Position
2. "RUN" Range
3. "FAST" Position
Figure 16. Start/Choke Control Positions
b. Next, move engine throttle control to "FAST"
position. See Figures 12, 13 and 16 starting on
page 7. Afterward, continue reading instructions
below.
If engine dies after engine throttle control is moved to
"FAST" position, repeat steps 2 thru 6 to restart engine.
7. If engine fires but does NOT continue to run, move
engine throttle control to "FAST" position and start
engine.
8. If engine fails to start after 3 attempts in the "FAST"
position, move engine throttle control to "CHOKE"
position and start engine.
9. If engine does NOT start after following steps 1 thru 8,
contact your Authorized Tecumseh Servicing Dealer.
DO NOT attempt to start or troubleshoot this engine in
any other way.
3
7 6 5 4
3
2
1
181-1215-14