Cleaning The Parksense® System; Parksense® System Usage Precautions - Chrysler 300 2014 Owenrs Manual

or the "SERVICE PARK ASSIST SYSTEM" message for
five seconds. Refer to "Electronic Vehicle Information
Center (EVIC)" in "Understanding Your Instrument
Panel" for further information. When the shift lever is
moved to REVERSE and the system has detected a fault
condition, the EVIC will display the CLEAN PARK
ASSIST , SERVICE PARK ASSIST , or SERVICE PARK
ASSIST SYSTEM message for as long as the vehicle is in
REVERSE. Under this condition, ParkSense® will not
operate.
If "CLEAN PARK ASSIST" appears in the Electronic
Vehicle Information Center (EVIC) make sure the outer
surface and the underside of the rear fascia/bumper
and/or front fascia/ bumper is clean and clear of snow,
ice, mud, dirt or other obstruction and then cycle the
ignition. If the message continues to appear see an
authorized dealer.
If "SERVICE PARK ASSIST or "SERVICE PARK ASSIST
SYSTEM" appears in the EVIC, see an authorized dealer.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 255
Cleaning The ParkSense® System
Clean the ParkSense® sensors with water, car wash soap
and a soft cloth. Do not use rough or hard cloths. Do not
scratch or poke the sensors. Otherwise, you could dam-
age the sensors.
ParkSense® System Usage Precautions
NOTE:
• Ensure that the front and rear bumper are free of snow,
ice, mud, dirt and debris to keep the ParkSense®
system operating properly.
• Jackhammers, large trucks, and other vibrations could
affect the performance of ParkSense®.
• When you turn ParkSense® off, the EVIC will display
"PARK ASSIST SYSTEM OFF." Furthermore, once you
turn ParkSense® off, it remains off until you turn it on
again, even if you cycle the ignition key.
3