Table of Contents
Advertisement
F. FINAL CHECKS BEFORE STARTING HEATER
1. Read Startup Procedures within this manual for proper steps to start heater. (See Startup Report to
record steps for future reference).
2. Verify heater and system are full of water and all system components are correctly set for operation.
3. Fill condensate trap with water.
4. Verify electrical connections are correct and securely attached.
5. Inspect intake piping and exhaust piping for signs of deterioration from corrosion, physical damage or
sagging. Verify intake and exhaust piping are intact and correctly installed per Venting section and local
code.
PART 10 – START-UP PROCEDURE
FOR YOUR OWN SAFETY READ BEFORE OPERATING
Before starting the heater, and during initial operation, smell near the heater and around the floor for gas
odorant or any unusual odor. Do not proceed with startup if there is any indication of a gas leak. Repair
any leaks at once.
This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the
burner. Do not try to light the burner by hand.
IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLOSION
MAY RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE. DO NOT
STORE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR
•
Do not try to light any appliance.
•
Do not touch any electrical switch.
•
Do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
instructions.
•
If you cannot reach your gas supplier, call the fire department. Installation and service must be
provided by a qualified installer, service agency, or the gas supplier.
A. OPERATING INSTRUCTIONS
If you smell gas, STOP. Follow listed safety instructions. If you do not smell gas, follow the next steps.
1. Turn on all electrical power to the appliance.
ANY OTHER APPLIANCE.
WHAT TO DO IF YOU SMELL GAS
49
Hide quick links:
Advertisement
Table of Contents
