Extension Cords - Luminar 66308 Owner's Manual & Safety Instructions

Grounding
TO PREVENT ELECTRIC SHOCK AND DEATH FROM INCORRECT GROUNDING
WIRE CONNECTION:
Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded.
Do not modify the power cord plug provided with the Light. Never remove the grounding prong
from the plug. Do not use the Light if the power cord or plug is damaged. If damaged, have it repaired by a
service facility before use. If the plug will not fit the outlet, have a proper outlet installed by a
qualified electrician.
Grounded Lights: Lights with Three-Prong Plugs
1. Lights marked with "Grounding Required" have
a three wire cord and a three prong grounding
plug. The plug must be connected to a properly
grounded outlet. If the Light should electrically
malfunction or break down, grounding provides
a low resistance path to carry electricity away
from the user, reducing the risk of electric
shock. (See 3-Prong Plug and Outlet.)
2. The grounding prong in the plug is connected through
the green wire inside the cord to the grounding
system in the Light. The green wire in the cord must
be the only wire connected to the Light's grounding
system and must never be attached to an electrically
"live" terminal. (See 3-Prong Plug and Outlet.)
Double Insulated Lights: Lights with Two Prong Plugs
1. Lights marked "Double Insulated" do not require
grounding. They have a special double insulation

Extension Cords

1. Grounded Lights require a three-wire extension cord.
Double Insulated Lights can use either
a two or three wire extension cord.
2. As the distance from the supply outlet increases,
you must use a heavier gauge extension cord.
Using extension cords with inadequately sized wire
causes a serious drop in voltage, resulting in loss of
power and possible tool damage. (See Table A.)
3. The smaller the gauge number of the wire,
the greater the capacity of the cord. For
Page 4 For technical questions, please call 1-888-866-5797.
3. The Light must be plugged into an appropriate outlet,
properly installed and grounded in accordance
with all codes and ordinances. The plug and outlet
should look like those in the preceding illustration.
(See 3-Prong Plug and Outlet.)
3-Prong Plug and Outlet
system which satisfies OSHA requirements
and complies with the applicable standards of
Underwriters Laboratories, Inc., the Canadian
Standard Association, and the National Electrical
Code. (See Outlets for 2-Prong Plug.)
2. Double insulated Lights may be used in either
of the 120 volt outlets shown in the preceding
illustration. (See Outlets for 2-Prong Plug.)
example, a 14 gauge cord can carry a
higher current than a 16 gauge cord.
4. When using more than one extension cord to
make up the total length, make sure each cord
contains at least the minimum wire size required.
5. If you are using one extension cord for more than
one tool, add the nameplate amperes and use the
sum to determine the required minimum cord size.
Item 66308