Samsung SH24TP6 A Service Manual page 10

2-2 Installation
2-2-1 Selecting Area for Installation
Select an area for installation that is
suitable to the customer's needs.
2-2-1(a) Indoor Unit
1. Make sure that you install the indoor unit
in an area providing good ventilation. It
must not be blocked by an obstacle affect-
ing the airflow near the air inlet and the
air outlet.
2. Make sure that you install the indoor unit
in an area allowing good air handling and
endurance of vibration of the indoor unit.
3. Make sure that you install the indoor unit
in an area where there is no source of heat
or vapor nearby.
4. Make sure that you install the indoor unit
in an area from which hot or cool air is
spread evenly in a room.
5. Make sure that you install the indoor unit
in an area away from TVs, audio units,
cordless phones, fluorescent lighting
fixtures and other electrical appliances
(at least 1 meter).
6. Make sure that you install the indoor unit
in an area which provides easy pipe con-
nection with the outdoor unit, and easy
drainage for condensed water.
7. Make sure that you install the indoor unit
in an area which is large enough to
accommodate the measurements shown in
figure on the next page.
2-2-1(b) Outdoor Unit
1. Make sure that you install the outdoor
unit in area not exposed to the rain or
direct sun light.
(Install a separate sunblind if exposed to
direct sun light.)
2. Make sure that you install the outdoor
unit in area allowing good air moment,
not amplifying noise or vibration, espe-
cially to avoid disturbing neighbors.
Caution :
It is harmful to the air conditioner if it is used in the following environments: greasy areas (including areas near
machines), salty areas such as coast areas, areas where sulfuric gas is present such as hot spring areas. Contact your
dealer for advice.
Samsung Electronics
(Fix the unit firmly if it is mounted in a
high place.)
3. Make sure that you install the outdoor
unit in area providing good ventilation
and which is not dusty. It must not be
blocked by any obstacle affecting the air-
flow near the air inlet and the air outlet.
4. Make sure that you install the outdoor
unit in area free from animals or plants.
5. Make sure that you install the outdoor
unit in area not blocking the traffic.
6. Make sure that you install the outdoor
unit in area easy to drain condensed water
from the indoor unit.
7. Make sure that you install the outdoor unit
in area which provides easy connection
within the maximum allowable length of a
coolant pipe(18
Note
1. Add (18 :30g, 24
(R-22) for every 1 meter if the pipe length
exceeds the standard pipe length of 5 meters.
2. Maintain a height between the indoor and out-
door units of less than 8 meters.
8. Make sure that you install the outdoor
unit in an area which is large enough to
accommodate the measurements
2-2-1(c) Remote Control Unit
1. Make sure that you install the remote con-
trol unit in an area free from obstacles
such as curtains etc, which may block
signals from the remote control unit.
2. Make sure that you install the remote con-
trol unit in an area not exposed to
direct sunlight, and where there is no
source of heat.
3. Make sure that you install the remote
control unit in an area away from TVs,
audio units, cordless phones, fluorescent
lighting fixtures and other electrical
appliances (at least 1 meter).
:15meters, 24 :20meters).
:40g) of refrigerant
2-5