Makita BHP448 Technical Information page 12

W
iring diagram
Fig. D-4A
Fix FET Lead wires as follows:
yellow with Lead wire holder nearest to Switch trigger
blue with the center Lead wire holder
black with Lead wire holder farthest from Switch trigger
FET
Lead wire
holder
FET
Fig. D-5A
Brush holder complete
Put Pigtail of Carbon brush
in the area marked with gray
color to avoid pinching with
Rear cover.
9 mm
Pigtail of Carbon brush
Wiring to Switch
yellow
black blue
Switch trigger
without Battery fuel gauge
available exclusively for North American countries
Wiring in Housing set (L)
9 mm
Put the bundled Lead wires
into the groove of Sponge.
Pay attention not to put
Lead wires on the Seal.
Lead wires connected to
Connector have to be fixed
with Lead wire holders.
Connect Lead wires to Switch, tilting their
Connectors to 45 degrees as dran below.
45 degrees
Seal
P 12/ 12