Using The Menu - Uniden UWS1113 Owner's Manual

Using the Menu

To open the menu,
press
Use
and
DOWN
to move
the cursor
Item
Audio Vol
Scan Time
CAM1 – CAM4
Pair CAM
System Setup sub-menu
Brightness
TV out
Power Save
Factory Reset
OK
Audio Vol
Scan Time
CAM1
UP
CAM2
CAM3
CAM4
Pair CAM
System
Factory
Use it to
Adjust the volume of the audio from the camera. Choose a value from 0 (off)
through 20 (maximum).
Set the length of time the receiver spends on each active camera during a scan
(see page 20) or activate quad display (see page 21).
Turn each of the four camera channels On (enabled) or Off (disabled).
Pair a camera to the selected channel (see page 18).
Adjust the brightness of the display. Choose a value from 1 (min) through 15
(max).
Change the video output format from NTSC (North America) to PAL (Europe).
Turn on power save mode. If you set this to field to Auto, the display turns off
if it's idle for more than one minute. (The audio will remain active.) To turn the
display back on, press
Reset the receiver to factory defaults. Any changes or settings will be lost.
The selected
item is
highlighted
10
OFF
ON
ON
ON
ON
1 2 3 4
Setup
To open the
System Setup
Reset
sub-menu, press
To close the menu, press
.
Ok
Use
LEFT
and
RIGHT
to scroll
9
through the
options for
the item
Brightness
TV out
Power Save
OK
OK
11
10
NTSC
OFF
15