Assembly Instructions - Landa SLT6-30224E Operator's Manual

Water
Inlet
Garden
89140020-17
STEP 1: Attach a 5/8" water supply
hose to inlet connector. Minimum
flow should be 10 GPM depending
on model of machine.
High
Pressure
Hose
89140020-19
STEP 4: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
Dipstick
89140020-22
STEP 7: Check oil level by using
supplied dip-stick. Use SAE20/40W
non-detergent only.
8

ASSEMBLY INSTRUCTIONS

Hose
STEP 2: Attach high pressure hose
to discharge nipple using quick
coupler. Lock coupler securely by
pulling back coupler collar, inserting
onto discharge nipple and pushing
collar forward until secure.
Spray Gun
89140020-20
STEP 5: Before installing nozzle, turn
on water supply and run machine al-
lowing water to flush through the sys-
tem until clear. Pull the spring-loaded
collar of the wand coupler collar back to
insert your choice of pressure nozzle.
Caution: Never replace nozzles with-
out engaging the safety latch on the
spray gun trigger.
Fuel
Oil
Tank
Gasoline
Tank
STEP 8: Fill gasoline tank and
check engine oil level. Fill fuel oil
tank. Do not confuse gasoline and
fuel oil tanks. Keep proper fuel in
proper tank.
Landa SLT/SLX • Gas 8.914-002.0 • Rev. 4/13
Discharge
High
Nipple
Pressure
Hose
Collar
89140020-2
High
Pressure
Nozzle
89140020-8
Wand
Safety
Latch
High Pressure
Hose
89140020-18
STEP 3: Attach variable pressure
control wand to spray gun using
teflon tape on threads to prevent
leakage.
High
Pressure
Nozzle
Wand
Collar
89140020-21
STEP 6: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
Red
Cable
89140020-23
STEP 9: Install proper battery
making sure that the red cable is
attached to the positive terminal.
Use a 12V group 24 style battery.
Trigger
Gun