Assembly Instructions - Oster 1693 Instruction Manual

INSTRUCTIONS FOR USE
BEFORE USING FOR THE FIRST TIME
Read and follow all the instructions for this section on use and care and find a place to
keep this instruction manual ready for future reference.
For your convenience, record the complete model number (located at the bottom of the
motor) and the date you received the product, together with your purchase receipt and
attach to the warranty and service information. Retain in the event that the warranty
service is required.
NOTE: The use of attachments not recommended or sold by Sunbeam Products, Inc.
may cause fire, electrical shock, injury or damage to the product.
Carefully unpack contents from carton.
1. Place Base on a dry, level surface.
2. Slide Motor Housing Assembly post onto Base and secure with Thumb Screws.
3. Position the Rear Grill over the Motor Shaft, making certain the 2 notches at the top
and bottom of the Rear Grill fit over the 2 prongs on the Motor Housing. Secure the
Rear Grill in place with the Rear Grill Mounting Nut. Turn Mounting Nut clockwise and
tighten firmly.
4. Position the Large Fan Blade, with hollowed interior of the Blade facing towards the
Rear Grill, firmly onto the Motor Shaft. Align the Motor Shaft pin with the recessed
groove in the back of the Fan Blade. Be sure the Shaft protrudes from the front of
the Blade.
5. Position the Small Fan Blade, with guide pins into the hollowed interior of the Large
Blade, and press firmly into place. Also be sure the Shaft protrudes from the front of
the Blade.
6. Secure the Fan Blade onto the Motor Shaft by turning the Blade Cap counter-
clockwise and tighten firmly.
7. Center the Front Grill by aligning the Oster
and then place into the Rear Grill. Snap the Front and Rear Grills completely together.
Tighten the Grill Screw at the bottom of the Rear Grill. Depending on the tension of the
Grill Screw, you may have to loosen it before securing the front grill. (NOTE: If Logo
Plate is not already assembled to Front Grill, you must attach it by aligning the slots
located on the back side of the Logo Plate with the notches in the grill center. Press
firmly into place.)

ASSEMBLY INSTRUCTIONS

logo horizontally and parallel to the floor,
®
3