Specifications; Dimensions - Ashly MX-206 Operating Manual

Operating Manual -MX-206 Stereo Microphone Mixer

8. SPECIFICATIONS

DISTORTION
THD at +20 dBu, 20Hz-20KHz, input switch at -40dB<0.05%
IMD (SMPTE) at +20dBu, input switch at -40dB . . . <0.02%
HUM & NOISE (20Hz-20KHz, input switch at -60dB)
equivalent input hum and noise . . . . . . . . . . . . . . . . . <-129dBu
residual output noise, TRS outputs,
all levels at minimum . . . . . . . . . . . . . . . . . . . . . . . . . <-100dBu
residual output noise, XLR outputs, . . . . . . . . . . . . . . <-90dBu
Master Level at nominal,
all Ch. Level controls at min . . . . . . . . . . . . . . . . . . . . <-84dBu
Master Level and one Ch. Level at nom. . . . . . . . . . . <-67dBu
MAXIMUM VOLTAGE GAIN (±2dB)
Mic Input to Master Output, 600 ohm load . . . . . . . . . . . 84dB
Aux In to Master Output . . . . . . . . . . . . . . . . . . . . . . . . . . . 34dB
FREQUENCY RESPONSE
20Hz-20KHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +0/-0.5dB
CROSSTALK
Between any inputs or outputs
20Hz-20KHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . <-60dB

9. DIMENSIONS:

8
Figure 9.1: Dimensional Drawing for MX-206 Mic Mixer
VU METERS
Two 5-segment LED meters . . . . . . . . . . . . . . . . 0VU = +4dBu
PEAK INDICATORS
Peak Clip indicator on each input channel and left and right
outputs, illuminates 3dB below clipping
PHANTOM POWER
+48 VDC applied to all Mic Inputs, switchable on front panel.
Maximum total current draw = 80mA. Maximum single chan-
nel current draw = 14mA. Gradual power-up and down to elimi-
nate "pops".
SHIPPING WEIGHT
10 lbs. maximum
POWER REQUIREMENTS
120 VAC nominal, 93 VAC minimum, 50-60 Hz,
17 watts (240 VAC available)
*unless otherwise stated, specification conditions are:
150 Ω source, Input set at "-60", all other controls set at
nominal, XLR output into 600 Ω or greater.
17.00