MSI ATX BX13 User Manual page 82

CPU Speed
Check your processor and set this function accordingly. If you set
this to Manual, you can set the CPU Ratio and CPU Frequency accordingly.
CPU Frequenies are: 66, 68, 75, 83 and 100, 103, 112, 117, 124, 129, 133, 138,
143, 148, 153. Though 68, 75, 83, 103, 112, 117, 124, 129, 133, 138, 143,
148 and 153 frequencies are available, it is advised that you use these only
for testing since this is not stable as the CPU is not designed for these
frequencies. CPU ratio are: 3, 3.5, 4, 4.5, 5, 5.5, 6, 6.5, 7, 7.5, or 8.
Note: If you set the CPU Ratio and CPU Frequency to be too high, and the
system will not turn on, then restart the system. Press "F10" until bootup.
This will set the default setting.
Chassis Fan Detected/Power Fan Detected/CPU Fan +1.5V
Detected/Voltage Detected/Vcore Voltage Detected/+2.5V
Voltage Detected/+3.3V Voltage Detected/+5.0 Voltage
Detected/+12V Voltage Detected/-12V Voltage Detected/-5.0
Voltage Detected/VBat Voltage Detected/5VSB Voltage
Detected
During Enabled, this will show the CPU/FAN voltage chart during
system boot up. During Disabled, this will not show.
Chassis Intrusion Detect
Set this option to Enabled, Reset, or Disabled the chassis intrusion
detector. During Enabled, any intrusion on the system chassis will be
recorded. The next time you turn on the system, it will show a warning
message. To be able to clear those warning, choose Reset. After clearing
the message it will go back to Enabled.
3-29
®