Makita BUR141 Technical Information page 7

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -3. Pipe section (cont.)
ASSEMBLING
Assemble Pipe section as drawn in Figs. 7 and 8.
Fig. 7
1. Insert Pipe cap into Pipe 25 so that the square
projection of Pipe cap fits in the left side of
Pipe as drawn below.
Next, mount Rubber pipe 25 and Lock
sleeve 25 onto Pipe 25.
Lock sleeve
Rubber sleeve 25
Pipe 25
Caution label
Two holes
on the pipe end
close to caution
label
Hole on the pipe end
Left
Square projection
Fig. 8
Caution label faced upward
3. Mount Lock off button B to Pipe holder (R)
so that the notch aligns to the triangle mark
as drawn below.
Note: Make sure that 2 pcs. of Rubber pin 6
are set in place.
Caution Label
Notch of Lock
off button B
Lock off button B
2. Pass Power supply cord unit through Pipe 25.
Fit the square projection of Pipe cap into the inner groove of
Handle (L).
Set Rubber sleeve 25 in place of Handle (L).
Assemble Handle (R) to Handle (L).
Power supply
cord unit
Right
Pipe cap
Triangle mark on
Pipe holder (R)
Rubber pin 6
(2 pcs.)
Symbol of
"Unlock"
Rubber sleeve 25
Pipe 25
Handle (L)
4. While aligning the triangle mark of Lock sleeve to
the symbol of "Unlock" on Handle (L), push Lock
sleeve toward Handle complete until it clicks.
And turn Lock sleeve until its triangle mark aligns
to the symbol of "Lock" on Handle (R).
Triangle mark
Lock
Symbol
sleeve
of "Lock"
Handle (L)
P 7/ 12
Caution label
Note: Face the caution label
upward as drawn in Fig. 8.
Square projection of
Pipe cap
Inner groove
as a guide rail for
Pipe 25 moving
Symbol of
"Lock"
Handle (R)