Makita BUR141 Technical Information page 6

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -3. Pipe section
DISASSEMBLING
(1) Remove Spool set and Safety cover as drawn in Fig. 2.
(2) Separate Motor housing (R) from Motor housing (L) as drawn in Fig. 3.
(3) Disassemble Pipe 25 complete as drawn in Fig. 6.
Fig. 6
1. Remove Lock off button B and
Compression spring 12.
Lock off button B
Compression spring 12
Pipe 25
3. Remove M6 Nut and M6x60 Hex bolt.
And remove Front grip.
M6x60 Hex bolt M6 Nut
5. Remove Handle (R) from Handle (L) by unscrewing
eleven 4x18 Tapping screws.
Pull out Power supply cord unit from Pipe 25 complete.
Pipe cap
Rubber sleeve 25
Handle (L) complete
2. Remove Pipe holder (R) by unscrewing four 4x18 Tapping screws
and disconnect Lead wires (black, white) from DC motor.
Note: Be careful not to lose Rubber pin 6.
Rubber pin 6
Handle (R) complete
Pipe 25 complete
Lock sleeve
Power supply cord unit
7. While pressing the projections
on the both sides of Pipe 25
complete, pull off Pipe cap
from Pipe 25 complete.
4. While aligning the indicator (triangle) on
Lock sleeve to the just center of "Unlock"
and "Lock", pull off it toward Pipe 25 side.
Indicator (triangle)
on Lock sleeve
Symbol of
"Lock"
6. Remove Lock sleeve and Rubber sleeve 25.
Lock sleeve Pipe 25 complete
Rubber sleeve 25
Pipe cap
Projections of Pipe 25
Pipe cap complete
P 6/ 12
Pipe holder (R)
Pipe 25
Symbol of
"Unlock"
Pipe cap