Connecting The Device In A Stack - D-Link DGS-3100 Series Installation Manual

DGS-3100 Series Gigabit Stackable Managed Switch Hardware Installation Guide

Connecting the Device in a Stack

The device can operate as member of a stack. The two HDMI stacking ports on the back of the device are used for full-
duplex stacking between units, and each port supports 5Gbps full-duplex traffic.
There are two stacking topologies supported by the device, the Ring topology or Chain topology.
Figure 3-6. Connecting the Device in a Stack
The device is "Plug and Play" in terms of stacking connection and configuration. Before powering up the device, connect
the devices into the required stacking topology. The Stacking Master and slave designations are configured through
automatic discovery. Manually changing the stacking configuration is through switch's web page and CLI commands, and
once the device has been booted and is operational.
26