Wireless Connection Test; Adsl Synchronization Test - D-Link DSL-2760U User Manual

Wireless n adsl2+ modem router

Table of Contents

D-Link DSL-2760U USER'S MANUAL

Pass:

Indicates that the Wireless interface from your computer is connected to the LAN port of your DSL Router. A flashing or solid green LAN

LED on the router also signifies that a Wireless connection is present and that this test is successful.

Fail:

Indicates that the DSL Router does not detect the Wireless interface on your computer.

If the test fails, follow the troubleshooting procedures listed below and re-run the diagnostics tests by clicking the 'Rerun Diagnostic Tests' button at the bottom of

this page. If all the tests pass, close and restart your Web browser to access the Internet.

Troubleshooting:

Verify that the Wireless configurations from your computer and your DSL router are matched and corrected.

Turn off the DSL Router, wait 10 seconds and turn it back ON.

With the router on, press the reset button on the DSL Router for at least six seconds and release it. This resets the DSL Router to its default settings. Wait

for the DSL Router to initialize, then close and restart your Web browser. To reconfigure the router, type your DSL Account username and password.

Pass:

Indicates that the DSL modem has detected a DSL signal from the telephone company. A solid DSL LED on the modem also indicates the

detection of a DSL signal from the telephone company.

Fail:

Indicates that the DSL modem does not detect a signal from the telephone company's DSL network. The DSL LED will continue to flash

green.

If the test fails, follow the troubleshooting procedures listed below and re-run the diagnostics tests by clicking the 'Rerun Diagnostic Tests' button at the bottom of

this page. If all the tests pass, close and restart your Web browser to access the Internet.

Troubleshooting:

Make sure your phone line is plugged into the modem.

After turning on your DSL modem, wait for at least one minute to establish a connection. Run the diagnostic tests again by clicking the Rerun Diagnostic

Tests button at the bottom of this page.

Make sure there is no DSL micro filter on the phone cord connecting the DSL modem to the wall jack.

Make sure you are using the phone cord that was supplied with your DSL modem or another similar phone cord with four copper wires visible in the plug.

If your DSL has been functioning properly for a long period of time and you suddenly are experiencing this problem, there may be a problem with the DSL

network. You may need to wait from 30 minutes to a couple of hours, and if you still do not have a solid DSL LED on your modem, call Technical Support.

Turn off the power to the DSL modem, wait 10 seconds and turn it back on. Wait at least one minute and if the DSL LED on the modem remains a solid color,