Table of Contents
Advertisement
D-Link DSL-2760U USER'S MANUAL
Step 3 - PPPoA
PPP Username and Password:
PPP Username:
Enter the PPP Account Username here.
PPP Password:
Enter the PPP Account Password here.
Authentication Method:
Choose an Authentication Method. If you don't know the
Authentication Method, leave this on Auto.
Enable Fullcone NAT:
Tick to enable Fullcone NAT
Enable NAT:
Tick this option to enable NAT for this connection.
Enable Firewall:
Tick this option to enable firewall for this connection.
Keep Alive PPP
Tick the option to enable keep alive function of PPP
connection:
connection.
LCP echo interval
Enter a time in second to determine how often to send an
(seconds):
echo message to an idle link.
IP fragmentation low
threshold:
The lowest threshold value for the LCP packet.
IP fragmentation high
threshold
The highest threshold value for the LCP packet
IP fragmentation time
(seconds):
Enter a time in second for IP fragmentation time.
Dial on demand:
Tick to enable Dial on Demand.
PPP IP extension:
Tick to enable PPP IP Extension.
Static IPv4 Address:
Tick to enable Static IP version 4 address.
IPv4 Address:
The option appears when Use Static IPv4 Address is
selected. Enter the Static IP version 4 address used here.
PPP Debug Mode:
Tick to enable PPP Debug Mode.
IGMP Multicast Proxy:
Tick to enable IGMP Multicast Proxy.
MTU:
Enter a maximum transmission unit value here.
Click Next to continue the setup.
39
Hide quick links:
Advertisement
Table of Contents
