Setting The Multi Room Setup - Sherwood R-904 Operating Instructions Manual

R-904(G)_ENG_091014:R-904(G) 2009-11-11 오후 12:05 페이지 41

SETTING THE mULTI ROOm SETUP

• The ROOM2 function allows enjoying one source in the main room and playing another in a different room at the same time.
MLT ROOM
• ROOM2 (ROOM2 mode) : To turn on or off the ROOM2 function.
• R2 (ROOM2 input) : To select the desired ROOM2 source.
• R2VOL (ROOM2 volume) : To adjust the ROOM2 volume.
■Notes :
• To select "MLT ROOM", set the "AMP" to "R2" first. (For details, refer to "When selecting the AMP ASSIGN" on page 35.)
• Only the analog input signal from the ROOM2 source can be heard. So, be sure to make analog audio connection and select
analog input for ROOM2 source.
1.
Press the CURSOR LEFT/RIGHT buttons to set the ROOM2 mode as desired.
• Each time these buttons are pressed, the ROOM2 mode changes as follows :
ON : To turn on the ROOM2 function. ("R2" lights up.)
↕
OFF : To turn it off. ("R2" goes off.)
■Notes :
• When the ROOM2 mode is set to OFF, you cannot select the ROOM2 input and adjust the ROOM2 volume.
• When you do not use the ROOM2 function, turn off the ROOM2 function to save electricity.
■When the ROOm2 mode is set to ON
2.
Press the CURSOR UP/DOWN buttons to select the desired item.
3.
Press the CURSOR LEFT/RIGHT buttons to set the selected item as desired.
■When selecting the ROOm2 input
• You can select the desired among CD, AUX, F.AUX, TUNER, VIDEO1, V2/IPD.
■When selecting the ROOm2 volume
• You can adjust the ROOM2 volume within the range of 0 ~ 80 dB.
ROOM2 : OFF / ON
R2 : TUNER / CD / AUX / F.AUX / VIDEO 1/ V2/IPD
R2VOL : 40 / MIN(0) ~ MAX(80)
41