How To Adjust Mounting Angle; Connecting External Devices To The Pdp - Samsung PS42E7SX Service Manual

Operation Instruction & Installation

11-2-5 How to Adjust Mounting Angle

1 Secure the SET to the wall mount bracket.(Please refer to the
follow ing instructions.)
2 Set the angle by pulling the upper end of the SET attached to
bracket in the direction of the arrow. (Refer to the illustration
on the right.)
3 The angle can be adjusted from 0° to 15° by ±2°.

11-2-6 Connecting External Devices to the PDP

11-6
1 Be sure to remove the safety pins underneath the PDP.
If the safety pins are not removed, the angle cannot be
adjusted. Any attempt to do so may cause damage to
the PDP.
2 Hold onto the bottom of the PDP and pull forward fully as
directed by the arrow as illustrated) to adjust the angle.
(0°~20° by 2°) Insert the Safety Pins to the front guide
holes on both sides as illustrated in figure
Viewing the PDP after connecting the external devices
Remove the Safety Pins to adjust the angle to 0°, and
then secure the Safety Pins again.
For safety, be sure to secure the PDP using the safety
pins. If the safety pins are not used, the PDP may fall,
causing serious injury.
Hold onto the middle of the PDP to
adjust the angle (not the sides of
the PDP).
.
Samsung Electronics