Summary of Contents for Samsung Plasma Display Panel Television
Page 1
PDP-TELEVISION LASMA ISPLAY ANEL Owner’s Instructions Before operating the unit, please read this manual thoroughly, and retain it for future reference. ON-SCREEN MENUS Picture In Picture (PIP) Energy Saving TELETEXT (Option) SRS TruSurroundXT Digital Natural Image engine Digital Terrestrial Receiver Register your product at www.samsung.com/global/register...
User Instructions ◆ Screen Image retention Do not display a still image (such as on a video game or when hooking up a PC to this PDP) on the plasma monitor panel for more than 2 hours as it can cause screen image retention. This image retention is also known as “screen burn”.
Contents ◆ G ENERAL NFORMATION User Instructions ... ■ Checking Parts... ■ Control Panel ... ■ Connection Panel... ■ Viewing the Remote Control ... ■ Installing Batteries in the Remote Control ... ■ ◆ O PERATION Switching Your Television On and Off ... ■...
Page 4
Contents ◆ U DTV F SING THE EATURE Previewing the DTV Menu System ... ■ Basic Functions... ■ 1 .Display Screen... 2. Volume Control ... 3. Select Soundtrack... 4. Select Videotrack... 5. Service List... 6. Program Information... Operating the DTV Menu ... ■...
Control Panel ➢ The product colour and shape may vary depending on the model. Front (or Side) Panel Speaker Œ SOURCE Displays a menu of all of the available input sources (TV, Ext.1, Ext.2, AV, S-Video, Component, PC, HDMI1, HDMI2, DTV). ´...
Connection Panel ➢ The product colour and shape may vary depending on the model. Side Panel Œ S-Video or Video / Audio L/R Video (S-Video or Video) and audio inputs for external devices, such as a Camcorder or VCR. ➢ Prolonged use of headphones at a high volume may damage your hearing.
Page 7
Connection Panel ➢ The product colour and shape may vary depending on the model. Rear Panel Ô ˝ ’ ” ☛ Whenever you connect an audio or video system to your set, ensure that all elements are switched off. ☛ When connecting an external device, match the colour of the connection terminal to the cable.
Viewing the Remote Control Œ Œ POWER button (turns the TV on and off) ´ ´ Number buttons for direct channel access ˇ ˇ One/Two-digit channel selection ¨ ¨ Channel control button (Refer to page 13) ˆ ˆ Selects the TV and DTV mode directly Ø...
Installing Batteries in the Remote Control Lift the cover at the back of the remote control upward as shown in the figure. Install two AAA size batteries. ➢ Make sure to match the “+” and “–” ends of the batteries with the diagram inside the compartment.
Freezing the Current Picture Plug & Play Feature Plug & Play Start Plug & Play Enter Exit Setup Plug & Play Language : English Time Game Mode : Off Blue Screen : Off Melody : Off More Move Enter Return You can freeze the picture when watching a television programme simply by pressing the STILL button.
Viewing an External Signal Sources You can switch between viewing signals from connected equipment, such as a VCR, DVD, Set-Top Box, and the TV source (air or cable). Press the MENU ( ) button to display the menu. Press the ENTER/OK ( ) button to select Source List.
Storing Channels Manually Manual Store Programme Colour System : AUTO Sound System : BG Channel Search : 62 MHz Store Move Enter Return Press the MENU ( ) button to display the menu. Press the … or † button to select Channel, then press the ENTER/OK ( Press the …...
Adding / Locking Channels ➢ Not available in DTV or external input mode. Using the Channel Manager, you can conveniently lock or add channels. Press the MENU ( ) button to display the menu. Press the … or † button to select Channel, then press the ENTER/OK ( button.
Sorting the Stored Channels Sort Prog. Name C -- C 74 C 75 Move Enter Return Assigning Names to Channels Name Prog. Name C -- ----- ----- C 74 ----- C 75 ----- ----- Move Adjust Return ➢ Not available in DTV or external input mode. This operation allows you to change the programme numbers of stored channels.
Fine Tuning Channel Reception ➢ Not available in DTV or external input mode. If the reception is clear, you do not have to fine tune the channel, as this is done automatically during the search and store operation. If the signal is weak or distorted, you may have to fine tune the channel manually. Press the MENU ( ) button to display the menu.
Customizing the Picture Settings Mode Mode : Dynamic Contrast Brightness Cool2 Sharpness Cool1 Colour Normal Tint G 50 R 50 Warm1 Colour Tone : Cool1 Warm2 Reset Move Enter Return Select the required mode by pressing the … or † button, then press the ENTER/OK ( Available modes: Dynamic, Standard, Movie, Custom Select the required option by pressing the …...
Digital NR / SMD / DNIe Demo Press the MENU ( ) button to display the menu. Press the … or † button to select Picture, then press the ENTER/OK ( button. Select the required option by pressing the … or † button, then press the ENTER/OK ( ) button.
➢ TruSurround XT, SRS and TruSurround XT technology is incorporated under license from SRS Labs, Inc. ◆ Auto Volume: On/Off Each broadcasting station has its own signal conditions, and so it is not easy to adjust the volume every time the channel is changed.
Time Features Press the MENU ( ) button to display the menu. Press the … or † button to select Setup, then press the ENTER/OK ( button. Press the … or † button to select Time, then press the ENTER/OK ( button.
Language / Blue Screen / Melody / Energy Saving Setup Plug & Play Language : English Time Game Mode : Off Blue Screen : Off Melody : Off More Move Enter Return ◆ Language It is variable depending on the model. When you start using the television for the first time, you must select the language which will be used for displaying menus and indications.
Screen Burn Protection To reduce the possibility of screen burn, this unit is equipped with screen burn prevention technology. This technology enables you to set picture movement up/down (Vertical Line) and side to side (Horizontal Dot). The Time setting allows you to program the time between movement of the picture in minutes.
Setting up Your PC Software (Based on Windows XP) The Windows display-settings for a typical computer are shown below. But the actual screens on your PC will probably be different, depending upon your particular version of Windows and your particular video card. But even if your actual screens look different, the same, basic set-up information will apply in almost all cases.
Setting the PC ➢ Preset to the PC mode by pressing the SOURCE ( Press the MENU ( ) button to display the menu. Press the … or † button to select Setup, then press the ENTER/OK ( button. Press the … or † button to select PC, then press the ENTER/OK ( Select the required option by pressing the …...
Previewing the DTV Menu System Installation > Select Country Installation Select Country Channel Organising Auto Scanning Manual Scanning Parental Lock Reset to Factory Defaults System Setup Channel Organising > Delete Frequency Installation Delete Frequency Channel Organising Delete Channel Delete All Channels Parental Lock Move &...
Basic Functions 1. Display Screen Before you can view the television program, you must perform the installation. Therefore you will see only menu images at first. After the television channels have been programmed, you will see the following picture (banner) each time you switch channels: Channel Number Signal Status...
Basic Functions Operating the DTV Menu Installation > Installation Channel Organising Parental Lock System Setup Installation > Select Country Installation Select Country Channel Organising Auto Scanning Manual Scanning Parental Lock Reset to Factory Defaults System Setup 6. Program Information EPG-Electronic Program Guide The electronic program guide gives you a programme list for the channels.
Operating the DTV Menu 1.1 Select Country To tune-in new channels, the TV has been provided with the option “Select Country”. Select the country where broadcasting services are provided. After selecting the “Select Country” from the Installation Menu, the following screen will be displayed: •...
Operating the DTV Menu Channel Organising > Delete Frequency Installation Delete Frequency Channel Organising Delete Channel Delete All Channels Parental Lock Move & Edit Channel System Setup Channel Organising > Delete Frequency Frequency List Program List 177500 [Digital] RaiUno 658000 [Digital] RaiDue 770000 [Digital] RaiTre...
Operating the DTV Menu 3. Parental Lock This “Parental Lock” feature sets viewing restrictions and prevents unauthorized access to your TV through the PIN (Personal Identification Number), which is a 4-digit number. (The factory preset PIN Code : 0000) On selecting this menu, you will have two options: to set lock for any desired channel and to change your PIN Code.
Operating the DTV Menu System Setup > Language Selection Installation Channel Organising Language Selection OSD Setting Parental Lock Time Setting System Setup System Information Software Upgrade System Setup > Language Selection œ œ √ √ OSD Language English Primary Soundtrack Italian - (ita, ita) Secondary Soundtrack Italian - (ita, ita)
Installing the CI card Purchase the CI CAM module by visiting your nearest dealer or by phone. Insert the CI card into the CAM in the direction of the arrow until it fits. Insert the CAM with the CI card installed into the common interface slot. ➢...
Teletext Feature Most television stations provide written information services via teletext. The index page of the teletext service gives you information on how to use the service. In addition, you can select various options to suit your requirements by using the remote control buttons. ☛...
Teletext Feature The teletext pages are organized according to six categories: Part Contents Selected page number. Broadcasting channel identity. Current page number or search indications. Date and time. Text. Status information. FASTEXT information. ➢ Teletext information is often divided between several pages displayed in sequence, which can be accessed by: ◆...
Page 34
How to Install the Wall Mount Bracket Instructions on Securing the SET to the Wall Mount Bracket ➢ The exterior of the SET may be different than the picture. (Assembly and installation of the plastic hanger is the same.) Remove the screws from the back of the PDP. Tighten the screws of the plastic hanger (shown in picture 2) to the back side of the PDP.
Page 35
How to Install the Wall Mount Bracket How to Adjust Mounting Angle ➢ Please secure the mounting bracket on the wall surface after setting its angle at 0° Secure the SET to the wall mount bracket. (Please refer to the following instructions.) Set the angle by pulling the upper end of the SET attached to bracket in the direction of the arrow.
Setting Up Your Remote Control After it has been set up properly, your remote control can operate in five different modes: TV, VCR, Cable, DVD, or Set-Top Box. Pressing the corresponding button on the remote control allows you to switch between these modes, and control whichever piece of equipment you choose.
Page 37
Setting Up Your Remote Control Setting Up the Remote to Operate Your DVD Turn off your DVD. Press the DVD button on your TV’s remote control. Press the SET button on your TV’s remote control. Using the number buttons on your remote control, enter three digits of the DVD code listed on page 40 of this manual for your brand of DVD.
Troubleshooting Before contacting the Samsung after-sales service, perform the following simple checks. If you cannot solve the problem using the instructions below, note the model and serial number of the television and contact your local dealer. No sound or picture ◆...
Page 42
Correct Disposal of This Product (Waste Electrical & Electronic Equipment) (Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources.