Equalizer Curve Fine Adjustment; Adjusting Bass - Pioneer DEH-P5450 Operation Manual

Section
Audio Adjustments
06

Equalizer curve fine adjustment

You can adjust the center frequency and the Q
factor (curve characteristics) of each currently
selected curve band (
).
HIGH
Level (dB)
Center frequency
1 Press
AUDIO
the Q factor (e.g.,
display.
2 Press
AUDIO
adjustment.
Press repeatedly to switch between the
AUDIO
following bands:
(low)—
EQ-LOW
3 Press 2/3 to select the desired frequency.
Press 2 or 3 until the desired frequency
appears in the display.
— —
LOW: 40 80 100
— —
MID: 200 500
— —
HIGH: 3K 8K
4 Press 5/∞ to select the desired Q factor.
Press 5 or ∞ until the desired Q factor appears
in the display.
— — —
2N 1N 1W 2W
Note
• If you make adjustments when a curve other
than
CUSTOM2
is updated.
28
En
EQ-LOW/EQ-MID/EQ-
Q=2W
Q=2N
Frequency (Hz)
and hold until frequency and
) appears in the
F-80 Q-1W
to select the desired band for
(mid)—
EQ-MID EQ-HIGH
— (Hz)
160
— (Hz)
1K 2K
— (Hz)
10K 12K
is selected,
CUSTOM1

Adjusting bass

You can adjust the cut-off frequency and the
bass level.
In mode, bass adjustment affects only the
FRT1
rear output: front output cannot be adjusted.
1 Press
AUDIO
Press
AUDIO
2 Select the desired frequency with 2/3.
Press 2 or 3 until the desired frequency
appears in the display.
— —
40 63 100
3 Press 5 or ∞ to adjust the bass level.
Each press of 5 or ∞ increases or decreases
the bass level.
increased or decreased.
(high)
curve
to select .
BASS
until appears in the display.
BASS
— (Hz)
160
– displayed as the level is
+6 –6