Abus Outdoor motion detector PIR User Manual page 19

Guide the standard 8-wire alarm cable through the cable input. Bare the wires and connect
to the detachable terminal block.
Screw the device onto the wall and make sure that the rear tamper is correctly positioned
and the switch is closed. See Fig. 4 and 5.
Two tamper feet are supplied as a reserve for the installation. One is 1 mm longer, the
other one is 2 mm longer than previously attached. This plug connection can be removed
by carefully pulling from the pin. See Fig. 2. When replacing the electronic module, make
sure that the LED is facing forwards to ensure the alignment of the sensor is correct (see
section on "Beam alignment & bypassing"). When the detector is correctly aligned and
installed, replace the front panel and lock it as shown. See Fig. 6.
Fig. 5
Fig. 6